At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
www.kia.ca/.../ownersmanual/2006_sedona_Owners_Manual_E...
Kia Motorsrecommended special tools, genuine Kia replacement parts and .... Room light main control switch.....3-123 ...... work properly, the power sliding door and ..... fuel only. • Check to make sure the fuel filler cap is securely closed after refu- .... roof, you have to reset your sunroof sys- ...... bulb check when you turned the ignition.
CHECK THE BULBS, YOU MAY NEED TO REPLACE THEM, ALTHOUGH IT WOULD BE ODD THAT BOTH LOW BEAM SIDES OF THE BULBS WOULD BE BAD, ALSO CHECK YOUR FUSE BOX AND LOOK FOR THE LOW BEAM FUSE, MY SEDONA HAS ONE, YOURS MIGHT HAVE FUSED OUT
FIRSTLY ONLY BUY QUALITY BULBS DONOT TOUCH THE GLASS PART OF THE BULB WHEN FITTING THEM. GET THE CHARGING SYSTEM CHECKED IF THE ALTERNATOR OUT PUT IS TOO HIGH THE FIRST THING TO BLOW WILL BE THE HEADLAMP BULB NEXT CHECK THE HEADLAMP IS SECURE AND NOT LOOSE ALSO THE BULB HOLDER IS CLIPPED SECURLEY AS THIS ACTS AS A HEAT SINK FOR THE BULB
Remove the headlight assembly. Just remove the 3 bolts with a 10 mm socket and pull it out so you can disconect the wire harness. After that pull the whole assembly out and unscrew the bulb cover. The bulb is held in with a spring clip.
Take screws off the front cover about 10-20 screws Reemove cover then two screws by the headlight Pull wole healight out, Repalce bulb. Not that hard. Read the manuel. My 16 year old did it with her Dad
Left front low or high beam headlight: remove battery, remove weather cap, pop-off 2-prong connector, depress spring holding bulb in position, use inspection mirror if necessary, one end of spring is caught beneath a lip, Move spring past lip and lift up, it will rotate upward and is fastened on opposite side. Remove old bulb, install new 55 watt halogen bulb (H7-55) available at Walmart. Install new bulb with tang in slot at bottom, fold over spring and depress to hook end under latch point, install 2-prong electrical connector, install weather cap, turn about 1/8 turn to lock into position. Reinstall battery, clean terminals and cable ends, place new no-corrode rings (available from Walmart) around battery posts, install cable ends, and tighten.
Right front headlights: not necessary to remove battery, otherwise same essential procedure.
Note: Lower and upper beams all use same H7-55 bulb.
×