Hello rockanddance: My name is Roger and I will help you. Use 5w30 weight oil in your engine. Unless the oil cap says to use 5w20 weight oil. Should you need further help please just ask. Please rate your answer. This way I know it was useful. Thank You for using Fix Ya. Roger
SOURCE: The best engine oil for Chrysler 2.7l 2005 in use in Nigeria
Yes it would. 2W20 is fine when then engine is new. Upon piling up the miles on the engine a heavier grade of oild is needed. the same for hotter climates evn if the engine is new
SOURCE: Adjust the headlights on 2005 Sebring, Touring Sedan
The adjustment screws/nuts should be located either on the top of the headlamp assembly,
behind the headlamp assembly, or near the frame rail by the radiator
support.
You will have vertical adjustment screws for each independent beam
(separate highs and separate lows, but will be same screw if highs and
lows are the same bulb). You may also have additional horizontal
adjustment screws as well
Park
your car on a level ground 30 feet from a wall and measure the height
from the ground to the bulb and mark on a wall. Also mark where the center of the bulbs would be (do this for highs beams
and low beams if the bulbs are separate, if highs and lows are the same
bulb, only do it for the lows)
For Low Beams: If the headlights read VOR, then
aim the brightest part or cutoff part just below the mark on the wall.
If it says VOL or nothing, aim them 2 inches below the mark on the wall. For horizontal, aim the hot spot directly at the line you marked for the center of your bulbs
For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.
2,009 views
Usually answered in minutes!
×