Underneath the car. somewhere near where the engine and transmission
hook up.
Removal & Installation
2.7L Engine
1. Remove or disconnect the following:
Negative battery cable from the remote ground post
Battery feed and posi-lock connectors
Nuts from the catalyst support bracket and mount
Starter heat shield
3 starter-to-engine/transaxle bolts
Starter by rotating it toward the engine and sliding it rearward between the catalyst and the engine mount
To install:
1. Install or connect the following:
Starter by sliding it forward between the catalyst and the engine mount and rotating it away from the engine
Starter and torque the 3 starter-to-engine/transaxle bolts to 40 ft. lbs. (54 Nm)
Starter heat shield
Nuts to the catalyst support bracket and mount
Positive battery cable and torque the nut to 89 inch lbs. (10 Nm)
Posi-lock connectors
Negative battery cable to the remote ground post
3.2L & 3.5L Engines
1. Remove or disconnect the following:
Negative battery cable from the remote ground post
Starter-to-engine/transaxle nut and bolts
Positive battery feed wire from the starter
Starter and position it to gain access to the posi-lock connector
2. Place a support under the engine and slightly relieve the pressure from the left engine mount.
3. Remove the 3 left engine mount-to-engine bolts.
4. Slightly, raise the engine to provide more room.
5. Remove the starter by sliding it rearward between the catalyst and the engine mount.
6. Remove the posi-lock connector.
Click image to see an enlarged view
Fig. Removal and installation of the starter motor
To install:
1. Install or connect the following:
Posi-lock connector
Starter by sliding it forward between the catalyst and the engine mount
2. Slightly, lower the engine.
3 left engine mount-to-engine bolts
Positive battery feed wire to the starter and torque the nut to 89 inch lbs. (10 Nm)
Starter and torque the starter-to-engine/transaxle bolts to 40 ft. lbs. (54 Nm)
Negative battery cable to the remote ground post
Hope this help (remember rated and comment this).
SOURCE: 2002 dodge intrepid won't crank
to get to the battery you neeed to removed the passanger side tire nad the is a plastic shiel you need to removed to get to the batery,
the starter is located on the driver side of the engine and you can see ie fron under the car, there are 3 bolts
2,497 views
Usually answered in minutes!
×