Service stability system message appears

Service Stability System Message The message center displays the service stability system message when any one of many VSES-disabling DTCs is set. The EBCM sends a serial data message to the IPC requesting this display.
It means there is a problem an till you get it fixed the stability control system is disabled ! ( EBCM ) electronic brake control module Has detected a problem an set a DTC - diagnostic trouble code in it's memory an had the message displayed !
Vehicle Stability Enhancement System (VSES)
The vehicle stability enhancement system (VSES) provides added stability during aggressive maneuvers. Yaw rate is the rate of rotation about the vehicle's vertical axis. The VSES is activated when the electronic brake control module (EBCM) determines that the desired yaw rate does not match the actual yaw rate as measured by the yaw rate sensor.
The desired yaw rate is calculated by the EBCM using, primarily, the following inputs.
?€¢
The position of the steering wheel

?€¢
The speed of the vehicle

?€¢
The lateral, or sideways acceleration of the vehicle

The difference between the desired yaw rate and the actual yaw rate is the yaw rate error, which is a measurement of oversteer or understeer. When a yaw rate error is detected, the EBCM attempts to correct the vehicle's yaw motion by applying brake pressure to one or more of the wheels. The amount of brake pressure which is applied varies, depending on the correction required. The engine torque may be reduced also, if it is necessary to slow the vehicle while maintaining stability.
VSES activations generally occur in turns during aggressive driving. When braking during VSES activation, the pedal may pulsate. The brake pedal pulsates at a higher frequency during VSES activation than during ABS activation.


It

are you driving over underground power cables when this happens?

The bolts that are holding the cover are loosing enough to allow the plate to move have the plate reset and the bolts installed with lock tie.

That is because you have not checked for codes,
diagnosed them & made the necessary repair, to
the system with a problem

Stability System actively monitors the movement of the vehicle and can adjust the movement of the vehicle in cases where it determines the car is not moving correctly, as in sliding on ice or snow.The system incorporates signals from the wheel speed sensors, yaw rate sensor, and steering wheel position sensor to determine any corrective action. Any failure of any of these components will result in a "Service Stability System" message.

PROBLEM COULD BE IN THE ELECTRONIC LEVEL CONTROL HEIGHT SENSOR IN THE CONTROL ARM. LET GARAGE CHECK IT OUT.IT TAKES DIAGNOSTIC EQUIPMENT TO CHECK OUT ELECTRONIC CONTROL SUSPENSION SYSTEM.

Sorry, but I do not understand what question you are asking. Can you please be clearer.

When I realized it would be a charge for your service, I simply called one of my locak dealers and got the information I needed immediately.

Pass this on to the public who pay you for history you simply collect collect and sell.

check your wheel speed sensor (s) could have a bad or broken wire causing these issues.