2004 kia rio... was driving on highway and then sudden loss of power... now starts but as soon as you touch gas pedal engine dies... recently changed motor and clutch and crank sensor
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Well, to begin with, the LAST thing I would replace if a vehicle died going down the highway is the starter. What caused the engine to die? It certainly was not the starter! If the starter will not crank the engine over, you probably have a dead battery. If your battery went dead while driving the vehicle down the road, you most likely have a bad alternator. However, it is really hard to say without actually being able to see the car.
Could be a transmission problem, or other fault. Best recommendation I can give you is get the Haynes repair manual for your vehicle and if an Auto Zone is close get them to read the fault code for you. That will tell you what the problem is and give you an idea if it's something you can fix.
had similar problem, 2003 rio 1.6l idle fine and die when trying to accelerate or lurch and die ran fine in reverse change timing belt,wires plugs, had codes for multi cyl misfire and low injector voltage, still same lurch and die. try wiggle test on sensor plugs and main engine harness between battery and engine . i did this and found car smoothed out,tried wiggle again and car died,took harness apart where i wiggled it and found broken wire to crank sensor.good now
check to make sure the vehicle is firing, by removing one of the sparks plugs wire and ground it our on the engine by placing a screw drive inside the end, if done correctly u should see spark
×