To locate the inline filter, follow the fuel line back from the throttle body. Inline filters are often mounted to the frame rail underneath the vehicle. It may be necessary to raise and safely support the vehicle using jackstands in order to access the filter.
Take out the carpet in the cargo area and lift up the floor cover to remove the fuel pump access cover. Unplug the fuel pump harness connector, then start and run the engine until it stalls to reduce the fuel pressure.
Fuel pump harness location-Pick-up models
To install the new filter, reverse the above procedure. A torque wrench is recommended to tighten the bolts for the fuel line banjo fittings. If the banjo fitting washers are damaged, replace them. Tighten the outlet fitting to 18-25 ft. lbs. (24-34 Nm) and the inlet fitting to 25 ft. lbs. (34 Nm).
Reconnect the negative battery cable, then start the engine and check for leaks.
×
1,269 views
Usually answered in minutes!
×