This is for the requested item:
Removal & Installation
Remove the locking fluid (paint) from threaded holes of the screws (A). Loosen the two screws (A) slightly, then pull the ignition/starter switch out from steering lock housing in direction of the arrow
To install:
NOTE
When installing the ignition/starter lock switch ensure that the ignition/starter lock switch and the lock cylinder are in the same position, e.g. "ignition on".
SOURCE: vw beetle 2002 2.0 115hp
Had the same issue. I replaced one of the fuses in the little case on top of the engine. Check the fuse diagram in the manual, locate the one for a/c. The fuses are color coded by amps, just buy the right color and push into place. (I did this after verifying my coolant levels were normal)
SOURCE: ignition switch for a 74 vw super beetle
The plastic ignition switch is held in with a philips screw. You will need to remove the ignition lock cylinder to get to it. A easy way to check is to unplug the wires going into the back of the lock housing and plug in the new switch, without removing anything.
SOURCE: how to change spark plugs for 2000 vw beetle
With the intake where it is this can be verry hard. You may have to pull the intake manifole to get it done. I can pull 1,3,4 but 2 is a problem. Check with a good auto parts store many times they have people with mechanical skills and loaner tools.
2,409 views
Usually answered in minutes!
×