1995 jeep cherokee automatic shutdown relay not sending power to distributer need wiring diagram

Your asd relay is located in the power distribution center near the battery. The inside label on the cover will give you the location.

check wiring diagram for the 1995 Jeep Grand Cherokee radio?

There is no "re-set" on that system. power comes from the fuel pump relay in the power distribution center and that relay is also fed by the auto shutdown relay in the same location. At the point you are at, you need to check those,as well as fuses and power at the pump harness to begin narrowing down the problem. Hopefully it will turn out to be something simple. If not I do suggest you get a decent manual (chiltons is pretty good on wiring diagrams).
If you need help with anything specific that you find, just ask and I'll try to help.

You don't have one. The pump runs from the relay in the power distribution center (Box near the battery with relays and fuses)and gets it's signal from the computer that is reacting to information it gets from the crank sensor and other sensors. If the computer sees no signal from the crank sensor it turns everything off by way of the auto shutdown relay (also in the distribution center)

CHECK ASD RELAY THAT IS AUTOMATIC SHUTDOWN RELAY IN THE POWER DISTRIBUTION CENTER UNDER THE HOOD IN ENGINE COMPARTMENT.IF ASD RELAY GOOD PROBLEM COULD BE CAMSHAFT SENSOR IN THE DISTRIBUTOR.TO SAVE TIME AND MONEY HAVE JEEP SCANNED FOR CAMSHAFT SENSOR AND CRANKSHAFT SENSOR FAULTS.

1998 Jeep Grand Cherokee Service Manual
http://rapidshare.com/files/138412864/ServiceManual.Jeep.Grand.Cherokee.1998_by_Parasico.rar
see ezg_8w.pdf, PDF page 46 of 448 for the junction box

SEE ALSO
http://www.scribd.com/doc/4790640/93ZJ-Secc-8W-Wiring-Diagrams
look for diagrams for fuse block, and relay center and power distribution center

fuse location is on front passenger side's side of dash (open door) OR underneath the dash, kick panel
the power distribution center is under hood.

Most often a relay will act like a buzzer if it is not properly grounded. The ground signal generally comes from the computer. The auto shutdown realy feeds the fuel pump relay and therefore is shutdown relay isn't getting the proper signal it will in turn send same improper signal to pump relay. I am sending you a decent diagram of this and suggest you first make sure all body grounds are clean and secure.
http://www.scribd.com/doc/18999822/Jeep-Wiring-2
Good luck!

Hi Larry, you can find all information about your Cherokee in here: Jeep XJ Cherokee 1995 - Repair Manual

Aboutthe headlights fuses, the light system have several fuses located inthe Power Distribution Center and Fuse Block, for more details, Isuggest review the Section-8WL-Wiring-Diagrams (page 149 and next). In the page 140, you can find the Diagrams Index and the Components and location about this.

Also can review Jeep XJ Cherokee 2000 - Repair Manual or the XJ 2000 08w-Wiring-Diagram-Part-I (page 21 and next).

Hope help you with this. Good luck (remember rated this help).

Number 11 is a 25 amp (natural) Headlamp delay module and also controls the horn.
Number 15 is a 15 amp (Lt. Blue) this controls the instrument panel lamps, headlamp switch, parking lamps and radio/clock memory.
number 17 is a 7.5 Amp (Violet) controls instrument cluster gauges, headlamp delay module, chime module, overhead console. I hope this helps because there are several different configurations for the jeep. So if this doesn't make sense then let me know and I will send you a different one.

Check fuses in power distribution box and auto shutdown relay. Also attempt to code check pcm if you can...don't think there will be any codes but make sure it has power.Also check to see if you have a white ballast resistor on the driver side fender...I think that sends power back to the pump. In that fails, make sure that the wiring below the really is actually sending power out...the relay may be fine but if wiring is corroded underneath it won't help