2002 Honda CR-V Logo
Ramaz Jimshitashvili
Ramaz Jimshitashvili Posted on Mar 02, 2010
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

As to me to stitch the second key from ignition (with immobilizer) in memory of my car (Honda CRV-2,4 EX 2002, made in UK) if nearby is not present diller from Honda.

Answer This Question

1 Answer

Anonymous

Level 3:

An expert who has achieved level 3 by getting 1000 points
All-Star:

An expert that got 10 achievements.
MVP:

An expert that got 5 achievements.
Vice President:

An expert whose answer got voted for 100 times.

  • Master 510 Answers
  • Posted on Mar 02, 2010
Anonymous
Master
Level 3:

An expert who has achieved level 3 by getting 1000 points
All-Star:

An expert that got 10 achievements.
MVP:

An expert that got 5 achievements.
Vice President:

An expert whose answer got voted for 100 times.

Joined: Dec 18, 2008
Answers
510
Questions
0
Helped
384375
Points
1812

Programming
When
Remote control added or replaced. System malfunction.
How
Obtain all remote controls. A maximum of 3 remote controls can be programmed. Switch ignition ON. Repeat procedure below 3 times: Within 4 seconds: Press lock or unlock button. Within 4 seconds: Switch ignition OFF. Within 4 seconds: Switch ignition ON. Within 4 seconds: Press lock or unlock button. System should now lock or unlock vehicle. Within 8 seconds: Press lock or unlock button of first remote control. System should now lock or unlock vehicle. Press lock or unlock button of second remote control. System should now lock or unlock vehicle. Press lock or unlock button of third remote control. System should now lock or unlock vehicle. Switch ignition OFF. Remove key. Check operation of all programmed remote controls.
NOTE: If less than 3 remote controls are to be programmed, remove ignition key after programming last remote control
NOTE THIS IS FOR YEAR 99-02

  • Anonymous Mar 02, 2010

    Close all doors and tailgate. Switch ignition ON. Repeat procedure below 3 times: Within 4 seconds: Press key/remote control lock or unlock button. Within 4 seconds: Switch ignition OFF. Within 4 seconds: Switch ignition ON. Within 4 seconds: Press key/remote control lock or unlock button. System should now lock or unlock vehicle. Within 4 seconds: Press key/remote control lock or unlock button. Within 10 seconds: Press lock or unlock button of second key/remote control. System should now lock or unlock vehicle. Press lock or unlock button of third key/remote control. System should now lock or unlock vehicle. Switch ignition OFF. Remove key. Check operation of all programmed keys/remote controls.
    NOTE: If less than 3 keys/remote controls are to be programmed, remove ignition key after programming last key/remote control.

    THIS IS FOR 02-07

×

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2006 Honda Odyssey. Junkyard switch, immobilizer, and key and won't start?
The Immobilizer needs to be reset to the vehicle so the ECM and BCM recognize it.

https://www.google.com/search?q=2006+honda+odyssey+reset+immobilizer

..
Read full answer
Aug 11, 2022 • 2006 Honda Odyssey
0helpful
1answer

2002 Honda civic ex will crank but not start
Sounds like the immobilizer is shutting down the fuel pump. Make sure any ignition/key is programmed to the car. There are issues with the immobilizer in these cars also, so you can visit some Civic forums to read further.
Read full answer
Aug 06, 2022 • Honda Cars & Trucks
0helpful
1answer

Honda 1998 accord ex v6 immobilizer issues 5 x green key light flash after key removed from ignition? No crank no start
Check the honda accord engine's electrical control system..
Read full answer
Sep 18, 2020 • Honda Cars & Trucks
0helpful
1answer

Where is the honda crv ex 2006 heater blower relay location - Inside heater blower motor runs with ign key off and removed and AC to off position
Fuses and relay Honda CR 2002 2006
Read full answer
May 02, 2018 • Honda Cars & Trucks
1helpful
1answer

Reset the ignition anti theft on my 2004 dodge stratus
If you are referring to the factory immobilizer, there is no resetting to be done.

The Sentry Key Immobilizer System (SKIS ) is designed to prevent unauthorized vehicle operation. The system consists of a Sentry Key Immobilizer Module (SKIM ), ignition key(S) equipped with a transponder chip and PCM. When the ignition switch is turned on, the SKIM interrogates the ignition key. If the ignition key is Valid or Invalid, the SKIM sends a PCI Bus message to the PCM indicating ignition key status. Upon receiving this message the PCM will terminate engine operation, or allow the engine to continue to operate.


For all faults except transponder faults and VTSS LED remains on steady. In the event of a transponder fault the LED flashes at a rate of 1 Hz (once per second). If a fault is present the LED will remain on or flashing for the complete ignition cycle. If a fault is stored in SKIM memory which prevents the system from operating properly, the PCM will allow the engine to start and run (for 2 seconds ) up to six times. After the sixth attempt, the PCM disables the starter relay until the fault is corrected.
Read full answer
Aug 14, 2013 • 2004 Dodge Stratus
2helpful
3answers

My car would not start after putting on new battery. All the lights come on when I turn the key on but when I try to start it I don't even hear a click.
IGNITION COIL sometimes the problem, try replacement products which is way cheaper. also have you checked your sparkplugs? they are only good for 2yrs sometimes not. also check your distributor cap where the sparkplugs cables are connected, and make sure you put it back same place and position. clean and with piece of cloth maybe it is wet or rusty. always disconnect the negative of your battery cable when doing under the hood. fill up your car wd 8 0z of fuel injector cleaner 8 oz. and let yourcar run for few minutes to eliminate carbon deposits cause to clogging. you can pull it out too if you wanted and disconnect the 2 hose and clips before you try to pull out the injector and spray with injector cleaner and leave it for 8 hrs and rinse it wd the same cleaner. MABUHAY PHILIPPINES
Read full answer
Jan 16, 2011 • 1999 Honda Accord
1helpful
1answer

I used the wrong Honda key in my 07 Odyssey. The ignition is disabled.How can I fix,
PUT THE RIGHT KEY IN THE IGNITION SWITCH TURN IGNITION SWITCH TO ON POSITION UNTIL IMMOBILIZER WARNING LAMP ILLUMINATES FOR FEW SECONDS.KEY HAS RESET.IF IMMOBILIZER WARNING LAMP FLASHES RAPIDLY KEY DID NOT RESET.TRY TURN SWITCH ON WITH KEY UNTIL IMMOBILIZER LIGHT ILLUMINATES FEW SECONDS TURN OFF YOU READY TO GO GO GO.IF CANT RESET HONDA DEALERSHIP HAS TO USE DIAGNOSTIC EQUIPMENT TO RESET KEYS TO IMMOBILIZER MODULE.
Read full answer
Nov 07, 2010 • 2007 Honda Odyssey
1helpful
1answer

I want added second ignition key for my vehicle.
hi i hope i am reading this right, you need your second remote key programing? here is how to do it please follow and do as it is important to get it right.....

repeat this procedure twice (2 x ) once for first remote, next with second remote. as follows

switch ignition on ( do not run )
within 4 seconds press unlock or lock button once
within 4 seconds switch ignition off
within 4 seconds switch ignition on ( do not run )
within 4 seconds press unlock or lock button once
the system should now lock and unlock vehicle
within 8 seconds press lock or unlock on the first key
the system should now lock and unlock
press lock or unlock on the second key ( new added one )
then the vehicle should lock and unlock ( do the above procedure with key 2 to program it )
hope this helps




Read full answer
Feb 22, 2010 • 2002 Honda CR-V
0helpful
1answer

The key symbol appears
That's your immobilizer system light:
The Immobilizer System protects your car from theft. A properly coded master or valet key must be used in the ignition switch for the engine to start.
If an improperly coded key (or other device) is used, the engine’s fuel system is disabled.
When you turn the ignition switch to ON (II), the Immobilizer System indicator should come on for a few seconds, then go out. If the indicator starts to blink, it means the system does not recognize the coding of the key. Turn the ignition switch to LOCK (0), remove the key, reinsert it, and turn the switch to ON (II) again.
The system may not recognize your key’s coding if another immobilizer key or other metal object is near the ignition switch when you insert the key. To make sure the system recognizes the key code:
Do not keep other immobilizer keys on the same key ring.
Use a plastic or leather key fob, not metal.
Keep other keys away from your vehicle’s key and the ignition switch while trying to start the engine.
Do not attempt to alter this system or add other devices to it. Electrical problems could result that may make your car undriveable.
This indicator will also blink several times when you turn the ignition switch from ON (II) to ACCESSORY (I) or LOCK (0).
If the system repeatedly does not recognize the coding of your key, contact your Honda dealer.
If you have lost your key and you cannot start the engine, contact your Honda dealer.
Hope this lets you understand the light, and what should be happening.
Read full answer
Dec 16, 2009 • 2002 Honda Civic
1helpful
1answer

My 2002 Honda CRV Vwarning tones for key left in ignition
broken drivers door switch you will find it has come apart can clip back together or new switch
Read full answer
Sep 24, 2009 • 2002 Honda CR-V
Not finding what you are looking for?

View Most Popular

2002 CR-V

  • Cars & Trucks

Related Question

2006 Honda Odyssey. Junkyard switch, immobilizer, and key and won't start?

  • 2006 Honda Odyssey

Related Topics

494 views

Ask a Question

Usually answered in minutes!

Popular Questions

What is the DRL warning light on the dashboard of

2007 Honda CR-V

Reset car alarm honda CRV

2003 Honda CR-V

Where is the knock sensor located on a 2003 honda crv engine

2003 Honda CR-V

2006 Honda crv, vsa, abs, and triangle light are

2006 Honda CR-V

1999 honda crv timing belt

1999 Honda CR-V

Check Out the Latest Top Trucks Report!
Check Out the Latest Top Trucks Report!

View all Fixya Reports

Top Honda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...