Driving a 2003 Ford windstar. Went to pass and RPM's peaked Van didnt seem like it was in gear. Stoped put van in park. Restarted motor ran smoothly. Van wont go forward or reverse,doesnt seem like it dropping gear. ???
Very common on this make and model trans, pump drive splines inside torque converter strip out and pump is not turning, Most times there is no damage to pump shaft. Remove trans and remove torque converter, inspect the splines at the very bottom of the hub hole. If stripped out inspected pump shaft splines which are the smaller center splines coming out of trans, if ok replace torque converter and re-install trans, change out fluid, clean any metal from magnet and replace filter, fill with fluid and verify proper operation.
792 views
Usually answered in minutes!
×