On this website you find fuse box diagram and description for Cadillac CTS
https://www.carknowledge.info/category/cadillac/cts
SOURCE: I have a 2005 Cadillac CTS. Both my brake lights
Check the fuse first, then check the Actuator by your brake peddle to see if it's needs to be adjusted or replaced. Good luck
SOURCE: location of the air bag sensor module
i do not know where it is but give these guys a try they sells only GM-parts only its Schram auto & truck parts 1-800-292-1032 and they website is www.schramauto.com if all fails stop by a cadillac dealership in the parts department and they be able to tell you sorry wasn't able to help you Michigan Man
SOURCE: how do I replace the tail light bulb on my
ok cadillac for some reason has to be difficult about these things you actually have to take the whole tail light assembly out. . .here is what youre going to need:
1. socket wrench
2. number 10 socket (gm's nut of choice)
3. patience because it is easy to drop the nut be careful
ok so you have to open the trunk then take the plastic that holds the carpet down off. you do this by unscrewing the black screw on pegs (not sure what to call these things). after you do this pull the plastic thing hard because it is being held in place by some pegs other than the ones you have already removed. then remove all the side carpeting depending on which side youre changing. ok after this look directly behind the tail light assembly for 2-3 (i forget how many) bolt like pegs (my new favorite word) these are attached to the plastic tail light assembly. then take the nuts off of these pegs and then you should be able to tug the assembly off. then you do what the others say take out the socket and replace the bulb.
like i said cadillac makes **** hard to do. if you hate this wait til you have to take the whole bumper off to replace the headlight bulbs (might want to invest in some hid lights so you wont ever have to replace them)
good luck
SOURCE: Replace 2005 Cadillac CTS water pump
drain the coolant.remove belt by rotating belt tensioner cllockwise. water pump pulley will require a holding tool to keep it from turning while removing bolts. access to air ratchet can sometimes eliminate the need to hold but be careful cause thats a good way to skin some knuckles. also make installation more difficult to obtain proper torque. after pulley is off just a few water pupm mounting bolts remain. clean and dry gasket surface very well before reinstalling.
Testimonial: "Very quick with a response, and good info!"
495 views
Usually answered in minutes!
×