I,m fitting ferodo brake pads to the front of my landrover discovery 300tdi /1998 -s reg. I've noticed that the new pads have an angled edge on the wearing pad at either the top or bottom. The pads can go in either way. Can you tell me if the angled edge goes to the top or the bottom.

steven martin

• 117 Answers
• Posted on Apr 13, 2009

SOURCE: need head bolt torque settings for 200 landrover discovery 4.0 liter 241 cu.in.

Stage 1 20nm
Stage 2 +90 degrees
Stage 3 +90 degrees

SOURCE: how to fit front brake pads on a landrover

Guys with questions on brakes scare me. They are the single most important system on any car. On the discovery the caliper must be removed by removing a brake pipe and therefore openeing the hydraulics, If the system is not bled properly, the brakes will be compromised.

SOURCE: i connect a 1997 landrover discovery computer to the 1994 landrover discovery and it won't start.

if it is a mems unit , it will need to be programed to the key fob and alarm . (there is no way round it).

SOURCE: heater not warm discovery 300tdi

i would check the thermostat first to see if stuck then check heater core

SOURCE: how to change front brake pads on a 97 landrover

Remove the road wheels, clean the exterior of the calipers. Remove the split pin from the retaining pins on either side and then remove the pad retaining pins and anti rattle springs. Remove the brake pads and clean exposed parts of pistons using new brake fluid. Wipe away excess with a lint free cloth. Using a piston clamp, press each piston back into its bore ensuring that the displaced brake fluid does not overflow from reservoir.
Refit the new brake pads, retaining pins and anti-rattle springs, using new split pins to secure them. Apply the service brake pedal several time to locate pads. Check fluid reservoir and top up if necessary using correct grade of fluid.