At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
I have a 2000 Jeep Wrangler Trouble Symptoms: -When lights are on, brake lights (all three) remain illuminated and only flicker when brake pedal is depressed. Facts: -With lights off, dashboard lights illuminate when brake is depressed -With lights on Brake Lights remain on in low bean, high beam, parking light mode. -Checked tail lights and all fillaments are good -With tail light bulbs removed and lights on, third light (cyclops) remains illuminated -With tail light bulbs removed and lights off, dashboard light illuminates when brakes are depressed. Where can I trouble shoot next?
Re: I have a 2000 Jeep Wrangler Trouble Symptoms: -When...
Sounds like wireing is shorted together. you need to trace down wires and check for bad spots in wireing. also be sure and check plug if you are set up for trailer lights.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
just because the tail lights work doesn't necessarily mean the bulbs are good, many brake/tail lights have multiple filaments in them, you can usually remove a bulb and tell with your naked eye if a filament has failed. Another possibility is a fuse. Are you getting power in and out of that brake light switch?
Well, the brake light circuit is always energized. If you have the vehicle off and press on the brakes, the lights should illuminate.
If the brake lights remain on without the pedal being pressed, something is wrong with the switch, located under the dash, along the pedal arm. This switch may need adjustment or replacement.
Just no turn signals in the back now? Maybe didn't install the bulbs tight back into the asm? No brake lights...do the lights work with headlights on and just no illumination with the brake pedal depressed? Could be brake light switch.
Remove wiring connector from switch and pry on switch to remove. Push switch into braket until it seats. Pull brake pedal rearward as far as it will go pedal tang will "ratchet" switch to correct position as pedal is pulled rearward. Reconnect the wires and check to see if it works.
Check the Inside Fuse Box with a Flashlight for Blown Fuses. Then Check the Fuse Relay Box Under the Hood. Check the Fuses in that one to, If the Fuses are all good, Locate the Illumination, and Brake. Replace these Relays. That should get them back on, Let me know! Please Rate my Response, I need all the Help That I can Get! Thanks!
hello sounds like a bad or loose wire on your brake switch up under your dash follow your brake pedal upward push down on your pedal now watch as you let it go slowley where it touches the skinny flat area of your petal touches a switch about 10 inches up from the bottom you should see a button sticking thru a bracket were your pedal touches check and jiggle wire if no lights change switch goodluck
×