Disconnect the battery negative cable.
Remove 12mm (3) and 14mm (4) bolts holding skidplate on and remove skidplate
Loosen the 14mm nut on the tensioner, then unscrew the tensioner adjuster bolt until the belt can slide off.
Unplug the alternator electrical connector.
Unbolt the alternator cable lug (12mm or 13mm depending on alternator manufacturer)
Remove lower 12mm bolt
Remove upper 14mm pivot bolt
Use large screwdriver to pry alternator off bracket, it pinches on when the pivot bolt is tightened.
Drop alternator out bottom of engine bay; helps to unbolt or bend transmission cooler lines out of the way.
SOURCE: i need to replace the
first remove the negitive battery cable . then remove the belt and elect connections and the bolts and it will come out a auto parts store can check your old one for no charge.
SOURCE: changing the alternator
By unscrewing the bolts off and push alternator down to take the belt off so you can pull out the alternator.
good luck
SOURCE: Changing transmission filter on Mitsubishi
FIRST YOU HAVE TO UNBOLT THE TRANSMISSION PAN ON THE BOTTOM OF THE TRANSMISSION. THERE WILL BE FLUID IN IT SO BE CAREFUL NO TO SPILL IT. AFTER THE PAN IS OFF YOU WILL SEE THE FILTER ON THE BOTTOM OF THE VALVE BODY. IT MAY BE BOLTED ON AS WELL. HOPE THIS HELPS. LET ME KNOW. GOOD LUCK
SOURCE: HOw to replace spark plug wires on a 1998
Installing New Spark Plug Wires Is Simple, Especially Of One Wire Is Replaced At A Time. Compare The Length Of The Old Wire With The Length Of The New Wire. Replace Each Wire With One Of Equal Length.Make Sure The New Wire Is Fully Attached On The Plug And In The Distributor Or Coil Module.
Spark Plug Wire Replacement Is More Complicated If All The Wires Are Removed At Once.Then You Must Use The Engine Firing Order And Cylinder Numbers To Route Each Wire Correctly.
539 views
Usually answered in minutes!
×