Brake pedal soft at times causing abs light to

Hi, you will have to get the ABS breaking system checked.

ABS light on C0265 C0201 U1041 Ricks Free Auto Repair Advice

e-brake pedal should go farther- is either out of adjustment or cable frozen- secondly sounds like only front brakes receiving enough pressure to "activate" properly- bleed all four brakes starting rear pass,then rear drive ,then front pass, then front drive- use plenty of fluid- bleed till fluid is clean without bubbles- will that long at first- this will insure not bubbles and no moisture- if a pro valve dies,you would have more problems- pedal would be really soft,would have both a brake light and abs warning lights

check for codes with scanner it most likely is the abs sensor on the rear differential housing that is bad easy fix

try bleeding the master cylinder at the lines first as it indicates that there is still air in the pistons
loosen one line at a time and gently apply the brakes until any air bubbles come out tighten the line before releasing the brake pedal
do it for the other line and then bleed all the brakes starting at the longest line first and ending at the shortest line

Have someone pump the brakes till they can't pump, hold pedal in and bleed them. Repeat over and over till you have brakes

sounds like you have low brake fluid pressure and the pressure sensor is turning on warning lights saying there is low pressure and also pedal going to floor indicate this, sounds like master brake cylinder is worn out/broke and needs replace ment

yes brakes need to bleed again starting with the caliper farthest from master cylinder abs pump is fine

Dd more brake fluid and make sure to bleed the lines...

depending on the system if it is 2 channel or 4 channel one of the sensors that are located on the backing plate located behind calipers is eithier faulty or dirty you can try brake cleaner these sensors use a small magnet pickup device to sense when the wheel "locks up"