The power seating is not working. The seat does not move foward

Check for an object in the seat tracks blocking movement. A napkin, a coin etc. .

if going backward is working,and foward is not,, easy
,1st determine what is defective-so u know what to replace/repair-2 things only ,[1-switch or 2- motor under d seat]
by presing the backward swicth,, you can hear the sound of the motor running and u can see the seat is going backward...
1-now by pressing the foward switch, and you hear the motor running but not that strong like the rear ..and the seat move an inche /a little and stop,,.then u have a defect weak motor,
2- now by pressing the foward swicth and u dont hear any motor running then the switch is most likely defective
defective switch -repair- spray contact cleaner,remove cover switch,penetrate inside
defective motor-repair-remove motor replace inside carbon,,.chiepest way not to spend to much money..
i suggest even once a month,lubricate all power seat/even not powerseat/,door hinges/.trunk door/.power antenna./ .by spraying lubricating oil,. for maintanace,..you can save a lot..

could be the mechanism to seat motor broken if seat motor and switch okay.

The seat has a transmission to move the seat up, down, foward , & back. Screw jacks adjust the seat up & down. Cables move the seat forward & back. The cable it seems had to break or the end of the cable has rounded out. Possibly the cable rounded out the seat it rides in the transimission housing too. You will need to remove the seat to find out

will or wont move foward?
you can get to the wiring block under seat. isolate wiring from motor 1 of three, (middle motor- foward back, front motor - front seat base up / down, back motor - back seat base up /down) does it work of mem. buttons? or when u lean seat foward (entry assist).

If the seat has a lever to allow entry to rear seat the fnt seat back and seat roll foward[2 door jeep]. Move the seat back back to normal and push loose seat all the way foward and then all the way back.let me know if that helps

The power seat relay needs to be replaced. The seat can not be moved manually unless it is removed from the car and taken apart

Check the voltage from the cpu,if there is none,replace the cpu again.Hold seat to foward for 12 seconds then release,wait 20 seconds,see if it will reset.If not replace the cpu

Thre's three motors or more that move your seat the one that controls foward/back went bad or harness under seat came apart.

try tapping on the front seat motor while moving the seat switch foward and backward.That is if this a power seat.