-
Expert
75 Answers
- Posted on Feb 03, 2010
Re: location of fuel filter 1995 Nissan Maxima
- This is if it is an internal filter, if it is not you still have to pull the whole bottom of the back seat out and look for the inspection plate.
- Relieve the fuel system pressure by first
removing the fuel pump fuse. Then, start the engine and allow it to run
until it stalls. Crank the engine for 2 to 3 seconds to release the pressure Turn the ignition off.
-
Step 2
Disconnect
the negative battery cable. Remove the rear seat bottom and the
inspection hole cover. Disconnect the electrical and quick connectors
and remove the six screws. Remove the fuel level sensor unit and the
fuel pump assembly. Then, take out the flange and snap fit portion of
the fuel pump.
-
Step 3
Remove
the fuel tank temperature sensor harness, the fuel level sensor flange,
and the fuel pump connector. Disconnect the quick connectors from the
fuel level sensor, and remove the fuel level sensor from the chamber.
Take out the fuel filter.
-
Step 4
Put
the new fuel filter in the chamber, followed by the fuel level sensor.
Attach the quick connectors to the fuel sensor. Connect the fuel pump
connector and put the fuel level sensor flange and fuel tank
temperature sensor harness back.
-
Step 5
Place
the fuel pump assembly inside the tank. Replace the screws and
electrical connectors. Reattach the quick connectors. Reconnect the
negative battery cable.
-
Step 6
Start your car
and check for leaks, and make repairs if necessary. When repairs are
complete, replace the inspection hole cover and the rear seat bottom.
×