I need a vacuum hose diagram for a 1995 nissan hardbody pickup w/ 2.4l 4cyl engine

i believe you are dealing with OBD-I

this may help you. pick el.pdf

http://www.nicoclub.com/FSM/Hardbody/1995

Can someone email this diagram to me I need it as well. We have a 1991 Nissan Hardbody we are putting back in today.

For 1995 Isuzu Truck Pickup 4WD 2.6L MFI 4cyl check this...

Fig. 16: 1988-95 2.6L Pick-Up (Federal)

Fig. 17: 1988-95 2.6L Pick-Up (California)


Hope this helps (remember to rate thuis answer).

On page 6-6, Hanes #72030, you will find the diagram that shows the EGR Valve for models 1981 through 1984.The diagram also is followed by models 1985 through 1997. The valve works exactly the same in the 1997 as it does in the 1984. If you need a diagram online, follow this link;

http://www.nissanpartszone.com/diagrams/large/D21U/nissan-hardbody-pickup-1995-1997-egr-parts-147a001.png

you crossed the egr valve hose most likely. there is a diagram on the underside of hood

Below is the vacuum diagram for your Nissan.
Good luck.
Regards,

FIG : Fig. 2: CLOSE X

truck normally has a vacuum hose routing diagram on under side of hood on drivers side.also look for metal tag on center of engine compartment fire wall which gives you a motor id @ and trk model # you can then know what engine vacuum diagram you need.i have a diagram for an 86 720 series Z24 carb engine that can be copied off of truck..chris

It's alot to handle at once but, I hope this helps you out...

<p>

http://www.courtesyparts.com/betasite/maxima-a32b-1995-1999/genuine-nissan-parts/engine-electrical/223-vacuum-piping/-c-1783_1784_1814_1817.html

The thermostat is located where the lower radiator hose goes into the engine. I've had to replace mine, and it took a while to find it. I found the easiest way to get at it is to remove the power steering pump (hoses attached) and set it over to the side to get at the bolts on the thermostat housing.

Good luck!