I have a 1993 k1500 4l60e, will a 94 s10 blazer 4l60e be compatible?

.....ask a Chevy dealer

https://www.google.co.uk/search?q=vacuum+line+diagrams+for+a+94+s10+blazer&es_sm=119&tbm=isch&tbo=u&source=univ&sa=X&ei=RoJmVMLgN8fzasiagcgP&ved=0CCIQsAQ&biw=1920&bih=985#tbm=isch&q=vacuum+line+diagrams+for+a+94+s10+blazer+4x4&imgdii=_

yes

For 1993 Chevrolet Truck S10 Blazer 4WD 4.3L CPI 6cyl the Engine Control Computer is located in front seating area, passenger side, behind dash, above glove compartment cavity, mounted on dash upper panel.

Hope this helps (remember to rate and comment this).

throttle position sensor, or check to make sure you have vacume going to the map sensor. Alot of times the outlet on the throttle body gets plugged and there is no vacume at the map--causes it to die. unplug the throttle position sensor and then rev it up and see if its better.

When everthing is tested or replaced then the only option is a bad computer. or maybe you have clogged injectors or fuel system in the rail

Installing the full-size Blazer trans into the S-10 would be safer. As long as they came off of the same size engine then yes, they will interchange. But.... the trans off of the S-10 is not built as strong as the trans for the full-sized Blazer, clutch capacity is less, band servo may have smaller apply area, and torque convertor stall speed may different enough to set a "code". Towing capability would be compromised. I have no idea what you meant by the "bolt for the plate".

Have the transmission governor checked

follow the upper radiator hose to the engine, under the nipple that the hose attaches to on the engine is the thermostat, 2 bolts and maybe a bracket VERY EASY TO DO.

i recomend getting a book from the auto parts store. it will have all the electrical diagrams. it costs less than $20.00 and will be a good investment. i have a book for all my cars and have never had to go to a shop.