How do I ajust idiling on 97 malibu

the crankshaft position sensor

Has anyone try to adjust the screw on the throttle,,that looks like a idle adjustment..If so that is preset at the factory,,and should never be adjusted...If the throttle plate angle is out of ajustment,,you may have to take to the dealer to get it back to factory specs...When ever that is moved,,it changes the voltage ,,

idle can be adjusted up with a screwdriver at the throttle body.

if it is a manual uaually u can put into 5th and then try reverse if this does work your syncros have gone out ine the trans

you will see a bracket under your vehicle to where the emergency brakes comes into ...reverse it ....there should be a nut to tighten too ....good luck ... try tighten it first ....before reversing it ...good luck

GO TO AUTOZONE OR YOUR LOCAL DEALER AND HAVE THEM PLUG IN THE DIAGNOSTIC MACHINE. IF THERE IS NOTHING WRONG HAVE THEM RESET IT. AUTOZONE WILL DO IT FOR FREE. DEALERS WONT

I don't know if this works on a Buick but I have had two cars that the auto adjusters worked when you used the parking brake, I rarely use the parking brake so I got in the habit of working the parking brake 20 times or so at oil change time.

If you just need an ignition key, take your title and ID to a Chevy dealer. They may be able to provide you with new keys.

these are hydraulic valves, no adjustment needed, with both valves fully open u back them off until they (rocker arms) are just slightly loose, then tighten them 1/2 turn, follow the firing order of the engine and bring it to top dead center (compression stroke) for each cylinder.

ok this sounds easy when you ran the vehicle the computer controled the idiling motor now that you replace the idiling motor the computer hasnt been reset to except the new parameters
once you reset computer this should bring the idle back down to its specified idle
you can also adjust back of gas pedel the idle cable and on the throttle body by the idling screw