Drivers side windshield wiper not moving

Vacuum line to the heater controll box has a leak or is disconnected.

Or the controlls went bad.

www.ask.com/schematic/drawings/1992/plymouth/sundance/2.5/engine/vacuum/lines/

Being front wheel drive you might want to check the engine mounts. When your driving it ,the engine will move because of the torque. this is normal . If the mounts are bad it might be rattling or rubbing on something .

Either the wiper arms are loose or stripped on the pivots or the wiper linkage is broken. Try tightening the arm to pivot bolt. If that doesn't work, remove the plastic cowling and examine the linkage. You can buy new linkage for it.

thats your axle its bad or you call it cvc joint needs to be replace it cost about $150

Either the linkage is stripped out or broke. I would look at the spindle that the blade attaches to. On the underside of it is a linkage that must have something wrong with it. Please rate my answer so I am rewarded points for it.

front of the engine see picture below.

Remove the arms,and place them back on where they need to go,do not turn the wipers on,do this as they set now.If the wiper blades when turned on go off the left side of the windshield ,then you will have to remove everything again,and move the wipers down in the rest position,and align everything up to the rest position,with the wipers at rest,and the motor at rest.

the wire is feed by the asd relay as commanded by the computer to supply power upon seeing cranking rpm. the wire also feeds the injectors and other sensors. the wire you need is in a harnes that runs from the drivers side to the passenger side just behind the back of the valve cover.
good luck chris

You broke the wiper transmission. Most of the time they are dealer only parts.