Windshild wipers stop intermittingly seems to

If the wiper keeps blowing, it should be because the wiring of the wiper motor is faulty. Send your honda civic to a repair shop.

Contact's in wiper switch worn or corroded! Replacement needed is it a ford? Or Toyota? :)

Check your fuses. All those items draw a lot of current and you might have blown a fuse.

My best solution, which you may not want to hear is new wiper motors. It seems like a common thing in these cars (the wipes don't go down all the way.

this might be a connection/ currosing problem. Check the windshild wiper relay for loose wires and then take apart the connection. Clean them up and put back together. also check your fuses.

Check the earth to the motor, Jaguars seem to be common for weak earth.

Hi I'm litoshop it looks like either the motor stripped the out put shaft or the linkege are not aligned before trying anything try to puch the wipers down if you can push them down then the out put shaft is stripped if not then you'll have to disconnect the out put shaft put the wiper blades on the right position and reconnect to the shaft and when I say the out put shaft is where the linkege connects to the wiper motor good luck if this information has been helpful please let us know thank you

could be fuse or wiper motor also switch . get a volt meter check power to the wiper motor and switch.

Both the 4X4 control module and the windshild wiper motor share a common ground point . G-301 , probably a lose connection. G301 kick panel, LH side

most likely the wiper motor quit working on you. This is very common on the Escorts and Probes.