SOURCE: location of crankshaft sensor chrysler
Heres adiagram to help you, its located at right rear of motor.
SOURCE: speed sensor
it has an input and an output spped sensor located on the front side of the transaxle
SOURCE: 2000 chrysler sebring 2.5 lite v6 were is the
like most other chryslers , might be on the rear of engine , gets its signal from points on flywheel
SOURCE: Where is the crankshaft position sensor located?
the crankshaft position senor on the 2.2L is located on the rear right side of the engine block
SOURCE: crankshaft sensor located 98 jeep grnd cher 4wd 6cy
it is located at the back of the engine on top of the transmission bell housing,the plug runs over to the passenger side of the engine bay and it comes out from behind the engine,you can actually get your hand on the sensor itself from under the hood on the drivers side,and i believe its a 13mm bolt holding it in,the new sensor will have a sticker on the end of it...leave it there,it is used for correct spacing between the sensor and the flywheel,hope this helps
Testimonial: "Everything was just like you said but as a not atleast for my jeep it is an 11mm not 13mm. Works great so far (keep fingers crossed) "
2,091 views
Usually answered in minutes!
×