How do I get to the blinker switch ? - 1994 Jeep Cherokee Country

Turn the 4 way switch on and off several times. Sometimes the connection that goes from turn signals and emergency
lights get dirty.

The multipurpose switch has separate circuits for the front and rear.

replace the hazard switch it works the blinker and hazard flash that's the problem bad hazard switch

there's a blinker relay usually in engine compartment sometimes right by battery. But it could also be your blinker switch is bad inside steering column.

There is only a few things that can cause blinkers to blink continually, meaning if your saying they wont shut off, Normally it is the blinker flasher or a fuse. Sometimes it can be in the blinker switch itself. I first would check the flasher, and turn signl fuse. If the blinker stays on and does not flash, still can be bad flasher or fuse or a ground problem, You would then have to check the wires around area where there contact to the tail light blinkers and front blinkers. But first start as said earlier with checking flasher fuse, switch and fuse. Mike

sounds like u have a shorted turn signal switch

your switch is faulty

Do the hazards work? Is it all the blinkers? If so try the flasher fuse otherwise make sure the hazard switch isn't half pressed down. Some cars you can hit the hazard switch just a little so hazards won't come on but neither will the blinkers. If it's just 1 blinker change the bulb

check the gruond in the black wire in the blinker switch if its ok, sometime the after market parts have ashort life time try to replace the flasher switch ( blinker switch)

change the blinker fluid jk remove the blinker switch fuse or power wire.