TRAC, VSC and Seat belt light is not going off - 2006 Camry XLE

Check engine light, VSC TRAC & TRAC OFF lights - Toyota ...

www.toyota-4runner.org/.../4164-check-engine-light-vsc-trac-trac-off-li...
Jun 6, 2004 - I just bought it, and a few days later the check engine light, VSC TRAC, and TRAC OFF lights all came on. I took it to a dealership and was told ...

VSC and TRAC OFF lights came on? - Scion xB Forum

those are the stability system (vsc) (helps keep the car pointed in the right direction during slick condition) and the traction control (trac)(helps by trying to prevent wheel slip during accelleration on slick condition) either you have turned it off with the switches. a fuse for those has blown, or there is a fault in the system . the car will still drive just fine. but you do not have the assistance of those systems

Check operation and condition of ABS sensors . Also check suspension and steering components and wheel alignment then retry and report back if necessary.

Check for codes & diagnose the new problem with the VSC

Tune-Ups ! --remember those back in the early 1980's, some
25 years ago,your not up to speed,you only get spark plugs

When the Trac off light is blinking it indicates an issue with the ABS system.


-----------------------------BMW ICOM BMW ISIS ISID A+B+C Plus

If the car has over 100,000 miles the timing belt may be getteing to long because of streching, this will cause the light s to go on because the internal timing in the motor is off. The code p0422 should not affect the other systems. Have the Tech check the camshaft to crankshaft corrolation with a scanner if he has one.

hey man sorry to tell you this but u will need a cat bank 2 its easy to take out it should only be 5 12mm nuts on the top and 2 14mm bolts on the bottom and some that r holding on to the trans.

You have to know what code is stored to fix the problem. Toyota's will generally display a Check Engine light, VSC and TRAC light all at the same time, even if it's a simple problem with an oxygen sensor (for example). You can disconnect the negative battery cable for a few minutes, even though you should a scan tool should be used, to clear out the code.

Here is your solution:
What you have is a bad seat belt receiver (the female part). There is a switch inside of the receiver that needs to close to ground when the seat belt male part is inserted. You can either replace the seat belt receiver, OR, you can do this: Look under the seat for the wiring harness going to the seat belt receiver. You will find a Red with a Yellow tracer wire. Connect this wire to a grounded part of the body (the bolt for the receiver, on the floor, is usually OK), and the light will be out forever.
Please comment back if this helps, or you have any other questions.
And, Thanks for choosing FixYA!

The Trac light comes on automatically, in conjuction with the Check Engine Light. You need your vehicle scanned for DTC codes.