The front lap belt will not automatically retract for a passenger to be restrained. How do I fix? This is on a 1994 Plymouth Sundance.

Hi Eric:
Blower Motor is usually only in one of two different locations... the first is on passenger side, access under the hood or, second choice, under dash access behind glovebox.

In both cases the resitor will be in the duct that the blower motor blows through.

Hope this helps; also keep in mind that your feedback is important and I'll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using Fixya, and have a nice day.

check relay in your electrical box on the drivers side under the hood

i need to find the timing marks are for a 94 plymouth sundance

try a camshaft poss.sensor or timing belt slipped

Hm. auto seat belt not moving points to a burnt out motor or a fuse is blown.

Have you had the starting and charging systems tested by Sears or Walmart?

How does it start?

To the rear of the gas tank under the car.

I have the diagram if you need it. Send me what you have posted here and I will send you the diagram.
[email protected]

you may have to remove the bolt that holds the buckle to the floor. Try to push the belt into the retractor and see if it frees up.

I assume you are saying it is in the locked mode. It has an automatic lock mode for holding a child seat. When the belt is pulled all the way out, it goes into locking mode. You will hear it ratchet when the belt starts going back in.



Section 01-20A: Restraints, Active 1999 Taurus, Sable Workshop Manual
DESCRIPTION AND OPERATION Safety Belt, Lap/Shoulder The dual locking mode retractor on the shoulder belt portion of the combination lap/shoulder safety belt for the front seat passenger and rear seat outboard passengers operates in two ways:

1. In the vehicle sensitive (emergency locking) mode, the shoulder belt retractor will allow the occupant freedom of movement, locking tight only on hard braking, hard cornering or impacts of approximately 8 km/h (5 mph) or more. The front and rear outboard seat belt retractors can also be made to lock by pulling/jerking on the belt.
   

1. In the automatic locking mode, the shoulder belt retractor will be automatically locked and remain locked when the combination lap/shoulder safety belt is buckled and does not allow the occupant freedom of movement. This mode provides tight lap/shoulder belt fit on the occupant and on a child safety seat or infant carrier installation restraint.
   

1. When the combination lap/shoulder belt is unbuckled and allowed to retract completely, the retractor will switch to the vehicle sensitive (emergency) locking mode.
   

WARNING: REAR-FACING INFANT SEATS SHOULD NEVER BE PLACED IN THE FRONT SEATS.
The automatic locking mode must be used when installing a child safety seat on the front passenger seat and rear outboard seats where dual locking retractors are provided

the ing. switch brake on these models replace the switch

check you r gas lines from tank to motor,fix leak 1st ,if it still idles high let us know