Disconnect battery negative cable Remove and Install Battery Cable
Raise vehicle.
For easier servicing, do not remove the wiring from starter at this time.
Remove three starter attaching bolts from engine/transaxle Starter -
Remove starter assembly from transmission housing. Position the starter to gain access to the wiring connectors.
Remove the battery positive cable nut from starter and remove the cable Wire Terminal Connections .
Remove the starter from vehicle.
INSTALLATION
For installation, reverse the above procedures. Clean corrosion/dirt from the cable and wire terminals before installing wiring to the solenoid.Thank you for using FixYa,Lee Davidian
SOURCE: Replacing a starter on a 1997 Dodge Intrepid
No, you can access the starter from the bottom of the engine without having to remove anything else. I replaced the starter on my 94 3.3 myself without having to remove anything else. Good Luck!!!!!
-Matthew
SOURCE: Front disc brake pads on a 1997 dodge intrepid.
The Calipers on the Rotor that Hold the Brake Pads have Bolts on the Back Side at the Top and Bottom for Mounting. Just feel around back there and you will find them. Remove these and the Caliper will come right Off. Let me Know if you need more Help! Please Rate My Response! Thanks!
SOURCE: bad starter
the book says you have to lift the moter up but i found out with a little time and a jack u can replace it without havein to do this it was frustrating but at least i didnt have to pay annyone to do it
SOURCE: my dodge intrepid 1997 3.5 liter shut down out of know ware, what could be the problem????
Crank and cam sensors
SOURCE: how to fix the gauges on a 1997 dodge intrepid?
check your instrument panel fuse in the fuse box, the instrument cluster is operated by the same circuit
1,005 views
Usually answered in minutes!
×