Open the hatch and the tailgate.
Remove the two mounting screws with a Phillips-head screwdriver, and remove the taillight assembly from the body by pulling it back.
Determine which of the three bulbs is burned out: brake/taillight, turn signal light or backup light. (I assume you’ve already determined this)
Remove the socket by turning it one-quarter turn counterclockwise.
Pull the bulb straight out of its socket.
Push the new bulb straight into the socket until it bottoms.
Reinstall the socket into the light assembly by turning it clockwise until it locks.
Test the lights to make sure the new bulb is working.
When reinstalling the taillight assembly, first place the two pins in the holes in place. Tighten the two mounting bolts.
Hope this is helpful to you.
2003 honda element both right and left taillight and brake light went out? Is this a bulb issue or somethng else?
Please help
It sounds more like a fuse burned out. There is a fuse box under the steering column. A map of the fuses is located on the door of the box. One should be labeled something like brake light. Find the corresponding fuse and check to see if it is burned out.
SOURCE: changing the tail light bulbs on a 2000 mazda 626
The Tail Lights Are Accessed From The Inside Of The Trunk There Will Either Be A Panel Immediately Behind Where The Light Is Or Carpet. Remove It And It Will Give You Access To The Rear Of The Bolts Just Grab Twist And Pull And The Light Will Come Out.
SOURCE: Both 2005 Honda Odyssey brake lights don't work.
make sure u have put the right bulbs in. rear brake lamps are dual filament....
SOURCE: i cant get the tail light out to change the bulb
No tools needed.
Beetles: Round plug inside trunk pops out.
Beetle Convts: Grille-looking rectangular panel pops out.
Reach in and you'll feel a large finger-grip able nut, back it off (DON'T DROP
IT) and place it somewhere retrievable. Take a small-flat-bladed screwdriver and wrap it in cloth so you don't scratch the paint. Poke said protected blade between the inside body joint and the tail light, gently pry tail light out. Remove offending bulb, replace with new. Installation is, as they say, the reverse of removal.
SOURCE: no tail lights or dash lights on my 1994 honda
Hello! Check Fuse #32 (15A) in the under-hood fuse box...
Guru......Saailer
I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867
SOURCE: change dashboard light bulb in 2002 Honda Accord EX V6
you will need fill up screw driver and a flat head remove the 2 screws that hole the BLK panel . then you use your flat head gently push up and out on the lower left and right coroners . be very carefull make sure you got time no rush. NOTE : make sure you go pick up the LIGHTS I USED sylvania lights part #74 LL YOU WILL NEED 14 OF THEM COST 4.99 FOR A SET OF 2 AND IF YOU HAVE AUTOMATIC CAR YOU WILL NEED CALL A HONDA DEALERSHIP AND FIND OUT IF THEY HAVE THE ONES THAT LIGHT UP WHEN YOU CHANGE GEARS.
5,939 views
Usually answered in minutes!
×