Where do i find the transmission dipstick at

fuse box diagrams

BMW 5-Series (E39; 1996 - 2003) - fuse box diagram ...

https://www.autogenius.info > bmw-5-series-e39-1996-...
Aug 26, 2018 - BMW 5-Series (E39; 1996 - 2003) - fuse box diagram. Year of production: 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003 ...
Missing: 740il ‎' Must include: 740il

• 
  

  BMW 3 Series E36 and E35/5 (1990 - 2000) - fuse box ...

  https://www.autogenius.info > bmw-3-series-e36-and-e...
  May 28, 2018 - BMW 3 Series E36 and E35/5 (1990 - 2000) - fuse box diagram · Front power distribution box · Relay carrier under LH side of dash · Connector strip ...
  

Picture & amperage & description of every single fuse ...

https://www.bimmerfest.com > ... > E39 (1997 - 2003)
Mar 1, 2013 - There are SIX fuse box locations in my 2002 BMW 525i E39 (here is a 1997 540i fuse location chart):. EF1 to EF5 <= at the back of the ebox ...

..

My 1989 735i has lifetime fluid (whatever that is supposed to mean) and thus is harder than most to change. This seems absurd to me as I would much rather change the filter and fluid once in a while than buy a new trans every 10 or 15 years. To add fluid, same as any other car--thru the dipstick tube. To change, remove the trans pan. If yours does not have a dipstick, I have no idea. Might be good to buy a shop manual if you plan on working on this car.

I believe it's right next to the dipstick on the block, attached with a 5mm hex bolt. Linked DIY should help. BMWTips M62 Camshaft Position Sensor CPS replacement

Hi there,

Transmission Fluid is the lifeblood of your auto and considered to be the one of the most critical components for a good working transmission, as the chemical makeup & viscosity of the fluid helps determine correct pressure and shifting. For this reason, use only BMW specified fluid - DO NOT use any non-approved fluid.

Measuring correct transmission fluid level is done after the engine/trans has WARMED UP.

If you measured your transmission fluid level using a dipstick, then you generally add BMW spec fluid through the same tube as the dipstick. CAUTION: never overfill the transmission, as excess fluid will cause 'foaming' and this usually creates further shifting issues.

If you have determined the fluid is low, the trans components will still function, but any attempt to operate the transmission in DRIVE with inadequate fluid, will likely cause unneccessary damage.

If there is no dipstick present, then this model BMW (much like the Merc's) denies you the ability to change your trans fluid yourself. This is a precautionary measure by the manufacturer to prevent the owner from changing the fluid. Instead, the workshop will have a special tool to measure the fluid level.

Cheers,


"If this has helped you in any way, please rate this solution"

Hey

They don't put a fill tube on them . It's suppose to be life time fluid. Must be filled from the fill hole and the plug is on the right rear side of the trans.

Hope this has helped
.

try lucas transmission additive.

And we're what?????supposed to draw it here. All this does is text.

THE sensor? what the....which sensor?

You must have a computer. Google for christ's sake.

you have to fill it through the dip stick hole.

put it down the dipstick hole for the trans.

Here is your Diagram . Good Luck leave me a fix ya comment http://www.2carpros.com/car_repair_information/tec_info/1994/bmw/740il/1994_bmw_740il_drive_belt_routing_diagram.htm