SOURCE: Removing the 100 amp fuse link in a 1994 toyota corolla
the fuse link is bolted in from the two side in the fusebox.you have to un bolt the whole fusebox so you can raise it and if you look at the sides there are two side panels that can be moved down so you can get a socket or spanner on the two bolts apprx 10mm. undo them and raise the fuse out and put the new one in and tighten up the bolts again. hope this helps.
SOURCE: 1994 toyota corolla alternator belt replacement
loosen the bolt that is holding the adjuster of the alternator. loosen the belt by pulling it and the alternator would slide in. remove and replace the belt.
do the reverse on installation.
remember to tighten all bolts of the adjuster and alternator after tightening the belt.
tnx 4 using fixya,
drcool
SOURCE: 1994 Toyota Truck 22R Engine
If you're doing it by yourself, drop the fuel tank.
Make sure it's almost out of gas first.
If you pull the bed, it's the bolts that hold the bed in, the wiring to the tail lights, and the tank filler neck to take loose. Then you have to pick up the bed of the pickup (a couple hundred pounds).
To get the tank out, it's the filler neck, and unbolt the straps that hold it in. Depending on how much fuel is in it, is how much it's going to weigh.
But as you loosen the straps, you can use a floor jack to hold the tank up. Same when putting it back in.
So I would go with taking the tank out, and not pulling the bed off.
SOURCE: toyota corolla 1994
theres no cable in toyota corolla 1994 check the speed sensor or replace speedometer have same problem with my 1993 toyota corolla
SOURCE: 1994 toyota fuel pump relay
Fuel pump relay is in the engine compartment left side fuse block
1,517 views
Usually answered in minutes!
×