Cars & Trucks Logo

Related Topics:

Posted on Jan 06, 2010
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Where do i find a knock sensor a 1993 gmc sierra

Where do i find a knock sensor on a 1993 gmc sierra

1 Answer

Anonymous

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

President:

An expert whose answer got voted for 500 times.

  • Master 1,608 Answers
  • Posted on Jan 06, 2010
Anonymous
Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

President:

An expert whose answer got voted for 500 times.

Joined: Jun 25, 2009
Answers
1608
Questions
0
Helped
748839
Points
5514

Should be on the right side of the engine by the starter.Has a 1 wire connector.It does not go into the cooling system so you can just take it out without draining the coolant.Hope this helps.Good luck.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

How many sensors does my 1993 gmc Sierra extra

Between the abs, transmission,engine, air bags , seatbelts, way to many to count off hand,what sensors are you asking about?
0helpful
1answer

How many o2 sensors do I have on a 1993 gmc seirra

I believe the 93 Sierra has only one O2 sensor. It is in the manifold on the drivers side. This assumes the 5.7L motor.
0helpful
1answer

Where's the knock sensors on a 2007 gmc serria 1500 5.3L

under the intake plentium right in the middle of the valley between the heads. bad for wires getting corroded and rusted. it holds water in the knock sensor holes, you can buy the harness
1helpful
1answer

1993 GMC Sierra SLE will not re-start after stopping and turning off the engine. It will start if you let it cool down for about 10-15 minutes.

Check manifold pressure sensor if present.
Check MAF sensor.
Check water temperature sensor.
Check O2 sensor.
3helpful
1answer

93 gmc sierra running rich no computer codes

Oxygen sensor[s],map sensor and fuel pressure regulator.Although you should have a check engine light "on" with any sensor malfunction.I would look at fuel lines for a leak under vehicle.
1helpful
2answers

I REPLACED MY KNOCK SENSORS ON MMY 03 GMC 6.0 AND NOW IT WONT IDLE AND IT DONT HAVE ANY POWER WHAT DO I NEED TO DO?

make sure they sold you the!! right 1 first off! and make sure the wire has continuity to the plug on each and and is securely fastened to the sensor also check to see if you knocked a wire off at the ignition module that controls the dwell
0helpful
2answers

2003 sierra truck 4.8 Lt. knock sensor location and replacement

I will be able to tell you. Just need to know if 2x4 or 4x4 and if it is 1500,2500, or 3500

Autozone.com and free registration = full free online repair manual
15helpful
2answers

2003 GMC Sierra Knock sensor and oil pressure??

the knock sensors are located below the intake plenum,or,upper intake manifold as some call it, they screw into the lower intake, the front one is sensor 1, the rear is sensor 2. it is wise to change both if you have some miles.since you are going to be buying a gasket set to do this job.the sensors are cheaper than the gaskets.
Not finding what you are looking for?

500 views

Ask a Question

Usually answered in minutes!

Top GMC Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...