Windshield wiper on car iced up during snow/driving could not see

It can be faulty wiper controlling switch or the wiper switch wires are shorting.

There are few solved solution help links related to wiper problem on various car brands and models.Select the required links and go through its troubleshooting procedure.
------------

1993 Ford F350 wipers not working?

http://repairhelpcenter.blogspot.in/2012/02/1993-ford-f350-wipers-not-working.html
--------- How to Replace a Windshield Wiper Motor

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-windshield-wiper-motor.html

--------
Wipers not working, but hear relay click on Lincoln LS? http://schematicsdiagram.blogspot.com/2011/12/wipers-not-workingbut-hear-relay-click.html
--------- Car windshield wiper gets power for movement and stops?

http://schematicsdiagram.blogspot.com/2011/12/car-windshield-wiper-gets-power-for.html

---------

How does cars Windshield Wiper System Works

http://technoanswers.blogspot.com/2011/11/how-does-cars-windshield-wiper-system.html

--------

1997 Honda Protege: Replace Wiper Transmission? http://technoanswers.blogspot.in/2012/06/1997-honda-protege-replace-wiper.html

-----------
For more help,keep updated.
Thanks.

The windshield wiper circuit has an circuit breaker in it, under heavy load this breaker trips to protect the wiper motor, when the motor cools, the breaker resets automatically restoring proper wiper action.

The inside of the wiper arm could be striped.I would pull the arm off and reset it on the windshield where its suppose to be and see what happens.That should fix it.

Hello: lift/remove cover from the lower end of the w/w arm (toward bottom of windshield) there should be a 13mm nut that attaches the arm to the transmission shaft. Use a 13mm box end and see if the nut is tight. If not tight position the arm in the proper position and tighten nut, re-install nut cover.

One thing that will help a lot is to remember to turn the defroster off before you get home. If you let the windshield cool and freeze while you run the wipers on a slow delay they won't freeze down. Guaranteed.

The other thing is to keep the area where the wipers park clear of snow and ice. Turn the key on, run the wipers until they're all the way up, turn the key off and get your plastic tool and dig that stuff out. Make sure there is somewhere for the water to drain.

lp

they are 22"
ACDELCO Part # 82221 {PERFORMANCE #89001016}
BLADE,WSW DRIVER OR PASSENGER SIDE; 4 DOORS; 22 INCH/565 MM

Remove the wiper arm and check the serrated hub to see if it sheared a pin holding it to the shaft. If it is ok, then you may have a broken/loose part in the linkage. Good luck!

While the wipers are in the parked state, just loosen off (or remove) the wiper arm from the drive spigot and re-position the driverside wiper arm to the correct position.
Re-tighten arm drive mount and all should be well.

hello, this sounds like your wiper transmission got out of alignment possibly due to ice on windsheild.don't really know.short of replacing you could loosen the nut under the cover and move wiper arm back possibly.

Check to see if the wiper motor moves the passenger side. If so, You may need to tighten the nut that connects the arm to the motor. Mine was stripped out because or snow & ice. So, I went to home depot and found a lock washer to fit.
Presto.... Nick from DE