SOURCE: 2003 silverado 1500 v-6 brake lights dont work
HI!!!! brake ligth swich is located inthe brake pedal on top get them off is hold it by pins o screws replace this thing only if you check the fusess and the are ok.
SOURCE: No rear brake lights on 2006 silverado
brakelight switch above brake pedal. sounds like the prob.at this point.
shack
SOURCE: 2007 Chevy Silverado Center brake light works but back ones dont
There is a probable bad wiring connection in problem one and three.
#2 Possible water leak causing bulb break. Try wd40 in socket. you need
a wiring diagam and cheap voltmeter if you want do it yourself.
SOURCE: Brake lights don't work. Replaced bulbs, checked
Yes, you need to of course check the voltage coming into and going out of the brake light switch, if 12 Volts are there going out and coming in while pressing on the brake pedal, your brake lights aren't getting a good ground or there is a break in the circuit between that switch & the lights.
On occasion the tail lights will work with a weak ground circuit where the Brake lights won't. Best way to determine this is to just hook up the 12 volt tester to the Brake light hot wire & there at the bulb ground, then in an area away from the bulb that has a good possibility of contact/ground.
Really that's it, if the 12Volts is getting to the bulb but it isn't lighting, if you aren't getting the voltage there and the brake switch is hot on both sides when pressed, the break in voltage will have to be traced from that switch to the tail light to find the problem.
good luck.
SOURCE: Brakes Lights dont work on a 2006 Chevy Silverado
I've worked on these the first drove me crazy. its the turn signal switch every thing runs thru these. head lights, turn signal, brakes. except the third brake light. it runs directly from the brake switch. go figuare
52 views
Usually answered in minutes!
×