How to remove the radio in 1994 nissan xe pickup. don't know where to begin taking dash apart...

SOURCE: 1994 Nissan XE Pickup Fuel Pump Noise???

here is how you can tell it is the fuel pump. turn your truck off. than have someone turn the ksy into the on position while they do that stand back at the end of the truck where the gas tank is located. when they key is switched to the one position thhe fuel pump should kick on and make a humming noise. if it is the same noise you hear when your ideling than that is you culprit.... my suburban does the same thing.

Marvin

• 85242 Answers
• Posted on Mar 25, 2009

SOURCE: nissa pickup wont idle at all

Here are the most common causes of surges, stalls at stops, low erratic idle speed and stall, rough idle and engine hesitation, it is in most cases the idle speed control air-bypass valve and or throttle valve and upper intake, these area's get full of gunk and combustion residue over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake.

SOURCE: How do you remove the door panel of a 1995 Nissan XE Pickup

Not sure about the 95, but to remove it on my 94 i just pulled on once corner till the fastener poped out, then worked slowly around removing each fastener. Be careful as the the door pannel is quite flimsy but if the 95 is the same as the 94 it should be fairly easy to remove.

SOURCE: Removing factory radio from 2000 Nissan Frontier XE

There are two screw at the bottom of the black plastic trim panel around the radio. Remove the screws and pull the trim panel back. Remove the four screws around the radio, unplug the wires on the back of the radio and you are finished!

SOURCE: where does the map sensor go in my 1997 Nissan

its near the evap canister purge control valve and the power steering resivior on the right (passenger) side of the engine compartment