Changed spark splugs on Ram 1500 and now engine is on

1996 Dodge ram 1500 NO ENGINE TOLD OF 5.GAS ENGINES
3.9 TO 8.0LITERS. AND A DIESEL NOT YOURS.
POST YOUR VIN AND WE KNOW WHAT ENGINE IS THERE. X5

SO IS AN AUTOMATIC TRANSMISSION?, YOU DID NOT SAY DRIVE IS STUCK IN 1ST GEAR.?
PRNDL
DOES REVERSE AND LO(L) WORK?
CHECK FUSES?
SCAN IT YET?
CHANGE SPARK PLUGS 1 AT A TIME?
IF YOU MESSED UP SPARK THE ENGINE WOULD SHAKE SUPER HARD AND HORRIBLE POWER AND NOT GO FAST ENOUGH TO GET TO 2ND GEAR.
IF ENGINE (NONE TOLD ) HAS COIL PACK WITH 2 OR MORE SPARK WIRES, THOSE MUST NEVER BE MIXED UP.

3.9 LITER
SPARK
The front coil pack fires six cylinders and the rearward coil pack fires four cylinders.
NEVER MIX THESE UP
5/10, 9/8, 1/6, 7/4 and 3/2.
END 3.9L EXAMPLE.


ONLY CHANGE SPARK PLUG 1 AT A TIME.
ONLY CHANGE COIL PACK HV SPARK WIRES, 1 AT A TIME
OR FAIL YOU WILL. (OR BUY NGK COIL PACKS THAT ARE MARKED CORRECTLY )

Yes you need a spark plug socket that fits your spark plugs

have you checked the coil(s) or ignition module?

if problems with hard start check heating coil in the intake side left on engine no spark plugs please dont even go to autozone n ask u look like a fool

You probably have a bad ignition coil. Which engine is in this truck? 3.7, 4.7, 5.7 or hemi

replace the ignition coils if you are having misfires. These engines are known for faulty coils. Replace all 8 spark plugs and coils. Does not require removing top part of the engine.

you can change the spark plugs enery 18000 - 20000 miles. take care.

YOU COULD BE HAVING ENGINE MISFIRE.DUE TO BAD SPARK PLUGS AND WIRES.ALSO DIRTY FUEL INJECTORS WILL CAUSE ENGINE TO ROUGH IDLE OR IDLE UP AND DOWN.PUT A BOTTLE OF FUEL INJECTOR CLEAN IN A FULL TANK OF GAS.ALSO CHANGE PLUGS AND WIRES.IF TRUCK HAS 30000 TO 60000 MILES ON IT.THATS THE SCHEDULE MAINTENCE INTERVALS IF SPARK PLUGS HAS NOT BEEN CHANGED.

may have a bad control module, when it dies try to see if you have spark at the splugs, try to detrimine if its a loss of spark. hope this helps,

hello, on your subaru when you have changed your spark plubs the computer neded to be reset . disconet the positif cable from the batterie then turn the ignition key for 2 minutes then, turn the key off , replace the batt cable and start the engine the ck engine light should go off......nicolas........