At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Hemi trouble i have an 05 dodge ram 1500 with a 5.7 hemi i've done alot of aftermarket upgrades, electric fan, harmonic balancer, cam shaft, 4.56 gears, pro charger super charger kit recently i added hid headlights since the headlights my truck won't run it will idle for about ten minutes then air fuel guage goes way rich an the truck stalls it won't go over ten mph. my mechanic can't find the problem and the dealer won't look at it because of the add ons
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
i have the same truck with hemi and i notice alot of power after i put on a cold air intake and i did a cheap one, i know the hemis say they have alot of power but i still think diesel is always the way to go when pulling..
pain in the ****. but can be done. its located on the rear of the motor on the drivers side compartment. it has 2 bolts that holds it down to the intake. it has a tube from the to the exhaust manafolds. I seen this problem alot lately.
Mark position of drive shaft and yoke - to install in the same position (not to upset balance) Remove and discard small "U" bolts on yoke Slide drive shaft up spline end to dislodge drive shaft from yoke. You can either "beat" U join out of shaft, but better to bring to auto parts store that has a machine shop to install new joint Use new "U" bolts to install Make sure "U" joint is fully seated in yoke and installed in same position as removed
×