My grans hyundai getz 53 reg had an abs fault, i tried my bosch kts an snap~on solus but would not give any fault codes, i borowed a friends diag tool an it found an engine mgnt fault in abs system, i cleared the fault, road tested the vehicle an the light came back on again the same engine mgnt fault, i road tested the vehicle with live data and found the n/s/f sensor faulty, today i replaced said sensor and tried the kts again the knock the fault code off and got c2402 (pump motor engine relay faulty) is there a seperate relay or is it part of the pump, dont want to get a pump at £200+ if theres another possible cause, thanks in advance pete

Hi from uk for your info there was a recall back in2004/5 for the getz relating to the abs system going faulty my wifes 2003 getz gsi was recalled and i took car to dealers for her to enquire what fault has there beenon some getz with abs system? as fault had not occured on ours ? apparently there had been a fault with the wire loom to pump particularly the earh cable deteriating ? so this loom had to be inspected and replaced under warranty however as i had waxoiled all underneath our getz including abs pump due to its location low down the loom was ok but was changed anyway and recorded and a dated sticker placed on cars glove compartment door inside to verify loom changed ? SO b4 you progress any further i would check with hyundai tech dept to whether you car had been inspected or whether slipped through unchecked ? your gran should have had a recall as we did for modified loom hope this helps?