1995 Jeep Grand Cherokee Logo

Related Topics:

Posted on Dec 05, 2017
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

My center console information center, will not hold its memory. After not driving for a while, like overnight. In the morning the date and time needs to be reset. The thing blinks and blinks until I put in the date and time. I think there is a memory battery, but don't know where it is located or how to replace?

1 Answer

Ronny Bennett Sr.

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Jeep Master 6,988 Answers
  • Posted on Dec 09, 2017
Ronny Bennett Sr.
Jeep Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Feb 28, 2009
Answers
6988
Questions
2
Helped
2285814
Points
21993

There will be a small amp fuse for this in with the other fuses. Use a test light to make sure the fuse is blown with key on test all fuses .The test light should light up on both sides of fuse if it is a good fuse.Only one side of fuse will light up for a bad fuse .Test light will have a clip on one end of a lead wire,clip it to a good known ground..The other end will be a sharp point. Use this to touch each side of each fuse to light the test light. NOTE some fuses will not light up at all on either side .These fuses are not hot unless activated such as lighting,this is normal.

5 Related Answers

SpaceCase521

  • 6 Answers
  • Posted on Nov 12, 2008

SOURCE: MY TIME DATE ARE BLINKING WILL NOT STOP CANT RESET

ahh the center warning panel is an easy fix. hold down both buttons on the right hand side till the hour numbers flash, use the select button to make changes, and the set button to switch modes.

Ad
motor1258

Mike Butler

  • 6674 Answers
  • Posted on Dec 21, 2008

SOURCE: 1997 Grand Cherokee Laredo

maybe washer fluid getting low?

ourhowse

Dar

  • 2007 Answers
  • Posted on Jun 09, 2009

SOURCE: replaced hood and now the information center

You will have to adjust your hood hinges or the latch part. They all slide just a little when you loosen the bolts.

jse2005

silvio potito

  • 103 Answers
  • Posted on Jun 30, 2009

SOURCE: My info center needs reset all the time. It's fine

you have bad or corroded electrical connections supplying the module...could also be bad ground.

silvio

Anonymous

  • 135 Answers
  • Posted on Sep 02, 2011

SOURCE: i just replaced the heater

have a dealer check it out,may have to have computer refalshed.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

How to set time and date on Mercedes benz SLK C200 model 2007

On center console knob select vehicle settings
click on that then choose time and date and select your actual time and date
0helpful
1answer

1998 Jaguar XJ8 had a short in the phone regulator and drained the battery.

You will need to replaced the components that liquid got in, no choice there..
0helpful
1answer

Front brakes lock up after 10 miles driving

faulty brake master cylinder
replace with a new unit and bleed the brakes
3helpful
3answers

How do you bleed a power steering pump

hi.
power steering pumps do not normally need bleeding. just slowly turn the steering from one side full lock, to the other side and back a few times. this will get rid of any air in the system. keep an eye on the fluid leve while you are doing it though.

any problems after doing this would suggest a different problem, rather than air in the system
12helpful
3answers

How do I reset my maintenance required light on my 2009 Avalon?

SWITCH IGNITION ON WITH ENGINE OFF.PRESS SMALL ROUND BUTTON ON LOWER RIGHT OF THE SPEEDOMETER UNTIL IT DISPLAY ODOMETER.THEN TURN OFF IGNITION SWITCH OFF.PRESS AND HOLD SAME ROUND BUTTON LOWER RIGHT SPEEDOMETER TURN IGNITION TO ON WITH ENGINE OFF.CONTINUE TO HOLD BUTTON FOR AT LEAST 5 SECONDS UNTIL IT DISPLAY INDICATES 000000 AND MAINT REQUIRED LAMP WILL EXTINGUISH.RESETTING IS COMPLETE.
1helpful
1answer

How to reset the clock on dash

I'm thinking that your talking about the VIC is the Vehicle Information Center... Its the display unit between the radio & the ashtray.

You have to hold the "set" button while the time/date is displayed. Use the set button to change each section, then select to cycle through.

Hope helps with this.
4helpful
3answers

Something is draining my battery

you need a mech you have a draw whitch meeans something is on at all times or internal short on something or pass bad batt.
make sure things ore off like dome light trunk light cig lighter out of socket cell phone charger etc. good luck
1helpful
1answer

1992 Sierra pickup how to set clock radio

Owners Manual Should have Instructions, I Cannot Locate ANY Such Instructions.
Usualy you Hold the Clock Button and use the Tuner control to change the time.
Below are Some Phone Numbers for TECH Support and Info on User Manuals.
I Hope This HELPS You with your Delima, I have Been there Myself so I Feel your Frustration.

Audio - Procedure To Handle Customer Radio Concerns Notes File In Section: 9 - Accessories
Bulletin No.: 68-96-O1A
Date: October, 1996
INFORMATION
Subject:
Procedure to Handle Customer Radio Concerns
Models:
1997 and Prior Passenger Cars and Trucks
This bulletin is being revised to change the Sales Center Information to
Service Center Information. Please discard Corporate Bulletin Number 68-96-01 (Section 9 - Accessories).
Many of the radios being returned to the Delco Electronics remanufacturing centers have been misdiagnosed. This misdiagnosis results in unnecessary customer comebacks, decreased customer satisfaction and reduces the availability of exchange radios.
To resolve these issues, the following information was developed to give General Motors' dealers a common service process to handle customer audio system concerns.
When a customer either calls or comes in with a concern about the radio system in their vehicle, it is important that as much information as possible is gathered. This process begins with the Service Consultant asking the customer specific questions related to their vehicle as outlined on the Service Writer/Customer Check list.
Once the Service Consultant has completed the diagnostic worksheet, it should be attached to the customer repair order for the technician. This worksheet should help the technician determine if the concern is vehicle related or radio related. Two excellent service manuals are also available for this purpose and are available from General Motors at the address shown below. A service bulletin, 34-92-12, Radio Frequency Interference Diagnosis, is also available as is assistance from the Divisional Technical Assistance Centers.
Mascotech Mktg. Service
1972 Brown Road
Auburn Hills, ML 48326
1-800-393-4831

Delco Electronics Sound Service Audio Systems Diagnostic Guide
P/N 19007.03-1A @ $10.00 per manual
STG Audio Systems Training manual
P/N 19007.03-2 @ $15.00 per manual

Repairs to the vehicle or the audio system can usually be done very quickly and the vehicle returned to the customer that day. If the diagnosis indicates that the radio needs to be replaced, remove the radio from the vehicle and order an exchange radio from your local AC Delco radio exchange center. There are 28 approved AC Delco exchange centers nationally (listing attached). If your local exchange center does not have the required exchange radio, it is important that you contact the AC Delco locator service. This service can be found on the Service Parts TRACS system 1-800-433-6961, prompt 4. It will be necessary to request overnight shipping so that the owner's vehicle is retained at your dealership for only one night.
If the vehicle is kept overnight and it is a warranty repair, the customer should be offered courtesy transportation or alternate transportation. Please do not return the vehicle with the suspect radio installed or without a radio. Many of our vehicles today use a multiplex wiring system and the vehicle will not run correctly without a radio.
When you receive the exchange radio, please return the removed radio to the AC Delco Exchange Center within 24 hours (please enclose the diagnostic worksheet that the Service Consultant and the Technician used with the removed radio along with the 1078 form). This will help the AC Delco Exchange Center.
In the event you know the vehicle will need a radio before the customer brings the vehicle in, every effort should be made to have a pre-exchanged radio available. A radio identification list is attached to help you select the correct radio
0helpful
1answer

Hard to start first thing in morning

I found the fuel rail shrader valve core was leaking out gas overnight. In the morning no gas in the system, started it and pumped the pedal, it started. I removed the shrader valve core and put in a new one. Fixed. A shrader valve core is like the one in your tires where you put air in, if it's loose it will leak air, if the seal is gone it won't hold air.
0helpful
1answer

1997 Grand Cherokee Laredo

maybe washer fluid getting low?
Not finding what you are looking for?

218 views

Ask a Question

Usually answered in minutes!

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...