1998 GMC Jimmy Logo
Posted on Dec 04, 2009

GMC Jimmy ''Limp Mode'' Woes

I have a 1998 GMC Jimmy 4wd with the 4.3 L V6. Since about two weeks ago, It started drive very sluggishly as I was backing out of my driveway, but would drive normally after a few seconds. This got a little worse and a little worse as time progressed. Then, I started it up one day and the battery was a little dead, but it started up, so I go to get on the highway when suddenly it endered 'limp mode'; where the transmission will not shift out of 2nd gear. So, I turned around and went home. When I tried to start it later to try to figure out what was wrong, my battery was dead as a doornail. After getting my battery charged at autozone, I *finally* checked my transmission fluid, and it was very very low... After filling it back up, I've tried everything I could find to reset the computer out of 'limp mode', (take out the ECM fuse for 30 seconds, disconnect the battery for a half hour) but still as soon as i hit the road I have nothing above second gear. How do I unset this?

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

  • Contributor 8 Answers
  • Posted on Dec 17, 2009
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Joined: Dec 16, 2009
Answers
8
Questions
0
Helped
4679
Points
10

Check the trans fuse...it blowing, will keep the car in limp mode, either that, or you need to replace Solenoid B, 1/2 Shift Solenoids...

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers
2helpful
1answer

1996 gmc jimmy will not shift to 3rd gear

Hi, It may be in LIMP mode.

What is "limp-home mode" ? This is a fault mode in which the transmission either loses electrical power or the PCM deactivates all of the electronics. The transmission will default to max line pressure. The driver will have Reverse and 3rd, with manual 2nd available by putting the gearshift in 2 or 1 (doesn't matter). 1st, 4th, and TCC lockup will not be available. It will not hurt the car to drive it like this for short periods, but use manual 2nd to get the car moving, and be aware that the trans will generate more heat than normal while operating in limp-home mode due to increased torque converter slippage during 2nd gear starts and no lockup in 3rd gear.

Common failures on 4L60E, symptom any possible repair:

Trans shifts into gear harshly, car feels sluggish off the line, No 1st, 4th or TCC lockup available, Manual 2nd, 3rd and Reverse are only available gears, CEL is on: Transmission is either in limp-home mode or has lost electrical power. If there are lots of error codes in the PCM, check the under-hood fuse that powers the transmission, and if it pops again, look for a short in that circuit like an O2 sensor harness touching exhaust. Otherwise, check PCM codes for a particular fault in the transmission causing the PCM to put it in limp-home mode.

No 1st or 4th available; trans shifts 2nd to 3rd by itself in D or OD and locks the converter :ShiftA solenoid failed. Easy fix in the pan. Or a wiring problem from PCM to trans.. or PCM.

Car goes into gear but feels very sluggish like the brakes are dragging, but it will roll easily (starts out in 4th gear), you manually shift to 2 to get it moving, once it's moving you put it back in OD and the car shifts 3rd to 4th on its own and locks the converter at the appropriate time: ShiftB solenoid failed: Easy fix in the pan. Or a wiring problem from PCM to trans.. or PCM.

Trans seems noisy when moving in 1st and Reverse, noise goes away instantly if you shift to N or the trans goes into 3rd gear: Reaction planetary is worn out due to high miles or insufficient lubrication. Not a critical failure, but not a good sign either. R&R sooner rather than later.

3rd gear starts, can manually shift through all gears. When car has been turned off for a bit, then back on it will run normally.: VSS dropoff w/ Hi-stall converter. The rpms are too high, but VSS is showing no movement. Happens after a tire burning take-off. Doesn't store a code, will not throw a CEL (I've heard that it will store a code if it happens 3 or more times). Cure: Reprogram PCM for VSS dropoff -- PCMforLess knows about it.

If you can get the Jimmy for no more then $500.00 and the engine sounds good and body is good, you may want to invest in the repair of the jimmy. Also note that to have a close look at the fuel line along the frame on the drivers side just by the back doors, the line is know to corroded there on all the SUV's
2helpful
2answers

1996 gmc jimmy won`t shift from 1st to 2nd

IF the abs dash light is on and if the speedometer is sluggish or not working at all, it is probably a bad speed sensor on the transmission. and easy fix under $40 for the part. Mine was stuck in second gear for a while then worked then it stuck in first gear and i had the CHECK ENGINE light on.
1helpful
1answer

I have a 99 GMC Jimmy with the 4 wheel drive. I

check fuse and relay to switch if power to switch retest switch new doesnt mean not defective if no power check connections and wiring for damage or breaks
1helpful
1answer

4L 60E - 2001 k1500 will not shift into 3-4. Oil is not burn't and stifts great into1-2

  • No 3rd or 4th gear: “3-4” clutches are worn out. R&R. The car is safe to drive (in 2) until you can get it fixed.
  • Trans shifts into gear harshly, car feels sluggish off the line, No 1st, 4th or TCC lockup available, Manual 2nd, 3rd and Reverse are only available gears, CEL is on: Transmission is either in limp-home mode or has lost electrical power. If there are lots of error codes in the PCM, check the under hood fuse that powers the transmission, and if it pops again, look for a short in that circuit like an O2 sensor harness touching exhaust. Otherwise, check PCM codes for a particular fault in the transmission causing the PCM to put it in limp-home mode.
  • No 1st or 4th available; trans shifts 2nd to 3rd by itself in D or OD and locks the converter : Shift A solenoid failed. Easy fix in the pan. Or a wiring problem from PCM to trans.. or PCM.
Check to see if your transmission is in the limp mode, which would only give you 2nd, 3rd and reverse gears. No 1st or 4th gear.
0helpful
1answer

2001 grand prix v6 check engine light stays on

Have you tried disconnecting the battery for at least 30 minutes? This is sometimes the case and the computer just needs to reboot. If that doesn't work, your o2 sensor has probably gone bad. Its not an expensive fix. Leaving the check engine light on puts the computer into a setting called "limp mode". Limp mode is a safety to prevent damage to your vehicle. In this case the computer thinks there is something wrong and by going into limp mode tends to give you less gas mileage and less power performance as well.
1helpful
2answers

I have a 1995 GMC Jimmy with auto trans., it wont shift into 2nd gear only shifts into drive when I get up to 2700 RPM and let off the gas and wont shift into overdrive at all. Does anyone know what causes...

Your going to have to get the Jimmy scaned before youhurt the transmission, It sounds like it's on a Limp mode which can range from a tune up to a bad ground. Good luck.
0helpful
1answer
0helpful
1answer

Need diagram for how the belts are run on a 1984 GMC Jimmy V6

I did not pay attention  but figured it out the alternator had a dual pully on it and the parts store sold me one with single pully. Took dual pully of old one an put on new one, the rest was easy.
Not finding what you are looking for?

1,651 views

Ask a Question

Usually answered in minutes!

Top GMC Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29494 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...