My 6 disc DVD changer will not eject, nor play. The lights blink back and forth from the 3 left lights to the 3 right lights, whether the van is on or off. I disconnected the battery to reset it, but to no avail. If I need to replace it, how do I best remove it? Thanks.

Stock CD changer stuck on EJECT - Maxima Forums

maxima.org/.../6th...maxima.../550345-stock-cd-changer-stuck-eject.htm...

Jan 9, 2008 - So when I tried to play a CD that has been in there forever, ... had that problem too! it would be in 50 degree weather.. discs wont change, play or eject. garaged the .... So last week I took my 06 (w/ Bose) in to the dealer for the stuck CD. ... said they send the CD player back to the factory and they will get the ...


Factory CD player

Aug 3, 2014


Bose 6 Disc Lockup CD ERR F0 !!FIXED!!

Apr 14, 2008


cd won't eject

Sep 8, 2002


More results from maxima.org

Nissan Maxima Car Stereo Removal and Repair - YouTube

? 8:52


https://www.youtube.com/watch?v=RT-SZEfeA4Q

Sep 16, 2012 - Uploaded by Factory Car Stereo Repair

Factory Car Stereo Repair ... Is it hard to fix cd inserting/ejectingproblem and what is needed? ... hey i ...

Happened to me as well. I first had it give me an error with disk 6 flashing so I removed it, put it back in and the lights would flash from 3 left to 3 right. I removed the DVD changer from the car again, removed the top (one screw), removed the black face plate (4 screws and carfully pry up on the bottom tabs when pulling it forward. I then took out the five screws holding the changer (four on top, one in the back) and removed the changer so I could get to the bottom. There is a set of wheels on the bottom that I started to turn which was easy at first but it seemed to reach a point where it was stuck so I gave it a bit more and something seemed to snap into position. So I assume that it was just the mechanism that jammed when it tried to switch disks. I put it back together, installed it, and it works fine now. When it first started all the lights would flash but then it settled down to a single light and I ejected the first 3 disks and number 6 and let it play the forth. Now to see how long it lasts.

There is a small pin hole on the door of most changers. straiten a paper clip insert in the hole ratchet back and forth on the gear in side to open.

If your radio works and you press mode .Does head unit recognize cd,s
It should display no cd,s cd error etc
The reason i ask this is to confirm that connection is ok to stacker
To eject PRESS AND HOLD eject button,insert credit card under cartridge,push fully in and move left/right untill eject
This will locate micro switch,so you can check discs

My endeavor has done this error 3 a couple of times and the cd changer basically shuts off all lights and won't do anything. Someone on another solution page said to slide a credit card back and forth in the cd opening to fix the problem. I've done this both times and it has made the changer play again as if nothing had happened : )

sorry unit is not servicable you can get a used one at many junkyards

Hi


Thanks for using FixYa. Locate your DVD player’s manual Eject button. It is usually a small hole located underneath the DVD drawer.

Use a stiff wire, a paper clip or safety pin—into the hole. Push gently and the drawer should open partway. Gently pull the drawer the rest of the way open and remove the CD.




Please do rate the solution and revert for further assistance.


Thanks

Rylee

use canned air and clean

Hi, this is a common issue within car CD changers. the load motor go through lots of trauma during the life span that i usually 3 to 5 years. the load motor operates everything in the changer. it works the load tray and spinning of the disc as well. when this motor is out, the changer will be rendered useless. replacing the load motor will fix this issue or, you can just purchase a new changer and save a lot of money.

you need to take it apart and clean it or send a disk in that cleans the inside.