What size Engine?
Most Camshaft Postion Sensors are located on the front of the engine on the passenger side, where the pulleys and belt is located. It is below the throttle intake, so take the Air Connection off. It located between the the power steering pump and the front engine mount. Follow two wires going straight down to the sensor. It is inserted into the Engine Block or Timing Chain Cover. Usually there is a 10mm bolt locking it into place. You must loosen (actually take it off) this to pull it out. The Sensor (is not screwed in) has o-rings and is a little difficult to pull out. Make sure you unplug the sensor and do not pull on the wires.
Hint: Put clean engine oil on the sides of the new sensor (on the o-rings) before to ease putting it back in. Make sure it is properly seated!
1,024 views
Usually answered in minutes!
×