2008 Chevy Silverado power lock problem

How to fix the Chev power window door lock switch - YouTube

? 5:04
https://www.youtube.com/watch?v=XDKaDURD8Sc
Jul 13, 2013 - Uploaded by spelunkerd
How to fix the Chev power window door lock switch ..... Some time later my drivers side window stopped working in the down position. ... These intermittent electrical problems are frustrating,aren't they? .... How To Install Replace Door Locks Chevy GMC Truck Silverado Sierra Yukon Tahoe Suburban ...

Diagnose Power Door Locks Dont Work Properly - Auto ...

www.auto-repair-help.com/.../diagnose_power_door_locks_dont_work_...

An inoperative power door lock can be caused by the switch, solenoid, wiring problem or ... Hi, I have a 2005 Nissan Sentra and the power locks aren't working. .... Hi, mypassenger door locks/unlocks both doors but my driver side door works independently and .... I have a 1986 Chevy Silverado K10 with auto door locks.

SilveradoSierra.com • 2003 silverado no power in right door ...

www.silveradosierra.com/.../2003-silverado-no-power-in-right-door-t30...

Slim Jims won't work on the door. There is a tool called The BigEasy unlock tool. You sneak it between the jam and door frame and hook it on the lock knob and pull it to unlock the door or push the power lock button to unlock the door.

This year model truck WILL allow the truck to be locked if the key fob is left inside, but not while fully engaged in the ignition. If you do not have Onstar service you will have to use a long piece of thin metal, possibly a straightened clothes hanger and work it into the upper part of the driver or passenger side door at the top rear corner. Be careful not to tear the door seal. If it's long enough to reach the power door lock button press it to open the door. If not then fashion a small hook on the end and hook the manual door lock release. There is just enough of a lip to hook on to. Hope this helps.

Probably is the actuator. Common problem. The actuator is part of the complete door latch. Hopefully that is what you got from 'Dorman'.

This is a very common problem on all chevy trucks for this year. The door lock solenoids are integrated into the door latch assembly, and are notoriously weak. They will work fine sometimes, others they just seem to barely move or not at all. You will need to replaced the door lock / latch assembly for the affected door.

Check the wiring at the door jam for breaks,

the most likely cause is the front axle shift motor if bad your your front axle shaft will not lock in.if there is no shifting of transfer case there is also a electric motor that engages that in .

this is posted in your owners man. i think you need to pull the high beem switch back and then hit the door locks once for on and twice for off depends, i have a crew cab so they have more door unlock lock choices

i work at a chevy dealership,just had the same problem my fix was to replace the power door lock relay located on drivers side interior fuse block