How to change wheel bearing on Toyota Camry? - 1988 Toyota Camry

If you have the bearings out then the number embossed in the face of the bearings is the part number and is good for all brands of bearings . If you do not have the bearings out then go to a bearing shop (cbc,bearing service, timken,skf etc) and they will have the numbers for your vehicle probably in a kit package. half the price of genuine for the same quality.. Just take the model, year , 2 or 4 wd and vin number to match the car with the bearing kit.

Have you checked if that noise is given by the tires? Usually I am facing this noise through my customers who are asking me to change bearings but on test drive I confirm the tires. Even on new TOYOTAS I found this problem. It is the tires quality used.

If you are refering to wheel bearings, then one of the best symptoms is to listen. Are you hearing a heavy drone that seems to cahnge in pitch, or go away when cornering? You can also lift the vehicle up and shake the wheels. Grab the top and bottom of the tire when lifted and move in and out. If there is movement, the bearing should be replaced.

sounds like bad wheel bearing, lift cars front wheels set parking brake, put car in drive, listen to each wheel to find bad baering good luck.

raise the front end off the ground on Jack stands. then try to find play on the wheel. it must be off the ground. I guess it your wheel bearings

it could possibly be the bearings are shot

The rear wheel bearing on a toyota camry is replaced by replacing the wheel bearing and hub as a unit. this is a design change as compare to older models with two piece wheel bearings. Scotch drive wheels. Remove rear wheel. Remove rear brake drum. (note: if emergency brakes are applied you will not be able to remove brake drum) Remove dust cap and hub retaining nut. Hub should slide off as unit. Replace hub with new unit. Installation is reverse of removal.

remove the wheel, disconnect the a arms upper and lower, tie rod end,brake caliper, remove the hub, remove wheel bearing, replace, repack, and re install

the bearing needs to be pressed in and out

you need to take the whole hub off and have it press off