How to reset tire pressure sensor light on 2007 ford expedition . check the tire pressure on all tires

use this link.
http://enginepartsdiagram.com/2007-2016-ford-focus-tire-pressure-tpms-sensor-light-reset/

Go to the "Discount Tire shop", and they will do it for you for free. Then learn how to spell. ??? air in tiers ???

Don't forget the spare tire pressure.

have someone take tire off and check the sensor it should be mounted on inside rim when u take tire off

Did you check the spare tire too?

need to set tires at correct pressure you can find a sticker on the inside of drivers door to tell you the correct pressure after you do that it sould reset the light after you drive

1. check and make sure that your tires are inflated to the correct pressure

2. turn the ignition switch to the ON position. If the low tire pressure warning light comes on, push and hold the tire pressure warning reset switch (think the switch is in the glovebox, but not sure) until the warning light turns off and then release the switch.

3. now press and hold the tire pressure warning reset switch until the low tire pressure warning light blinks three times.

4. initialization is *not* completed until driving at the vehicle speed of 19 mph or over for more than one hour. the tire pressure monitoring starts when initialization is completed.



As for the ABS light, that means your antilock brake system has detected an issue such as a block sensor, or a faulty relay, etc.. when this light is on, it means that your abs may not engage when it should, or may engage when it shouldn't.

Have you checked tire pressure? It will come on if your tire pressure is just a few pounds low.

check not only the tires on the car, check the level on the spare tire to, cause some of those have the sensors also... most cars will reset the light once you have the pressures right and drive on the tires a few miles to reset the light.... hope this helps you..

It's also a good idea to reset the tire pressure sensors when you air up the tires. If I remember correctly, you click the odometer/trip meter switch until it flashes TIRE RESET (or something similar) then press the button and hold it for a few seconds. That way it sets itself to the pressure in the tires at the moment, and if it notices a pressure drop it puts up a warning.