My ABS light on my 99 subaru outback has been on. we were able to turn it off by replacing a blown fuse but now the ABS keeps kicking in everytime I stop making the brakes pulsate. I needed the light to turn off in order for it to pass inspection but now the brakes are pulsating. any idea what I can do?

mx5turbo92

• 545 Answers
• Posted on Jun 04, 2009

SOURCE: i have a subaru legacy outback, abs light comes on

one of your abs sensor is bad or the abs motor,go to local shop to diagnose which sensor,shop usually charge $ 60 to diagnose abs system,good luck, let me know ..

SOURCE: water in front blinker 99 subaru outback

After removing housing there are 2 clips top and bottom that release the lens. Make sure and use sealant when reinstalling. Good luck and have a great day.

SOURCE: '99 subaru legacy gets 2 flashes from LED and

try opening door and holding unlock button ,it sounds like its in valet mode

SOURCE: what causes pulsating brakes in a 96 subaru

Assuming you are not referring to the pulsation experienced when the anti-lock braking system engages, you should replace the rotors and the pads while you are at it. The days of turning or resurfacing rotors are over. They are cheap.

SOURCE: check engine light on in 2001 subaru outback - car

If the light was flashing when it came on, then it means your engine is misfiring.

A solid light can mean anything from a loose/faulty gas cap to a transmission issue.

This light comes on when the computer detects a fault of some sort in its diagnostic tests. If it keeps detecting this issue, the light will remain on. If the light turns off, then it has detected that the issue may no longer be present.

In order to find out what the exact reason was for your light, You need to have your car computer scanned to retrieve the code that the computer would have stored when the light triggered. Most garages will do this free of charge. The code will tell you what may have caused the light to initially turn on.

Testimonial: "thanka "