How do you replace headlights 94 dodge intrepid

SOURCE: adjusting the headlights on a 99 dodge intrepid

On the back of the headlight their is a bolt which you could turn it one way and it lowers the headlight the other way it picks it up.

Marvin

• 85242 Answers
• Posted on Jun 18, 2009

SOURCE: how to adjust timing for 94 dodge intrepid

1st the belt must ALWAYS be replaced when the water pump is done or anytime the belt is distrubed, here are the only instructions I could find on the belt replacement.
http://www.allpar.com/fix/timingbelt35.html

SOURCE: 1996 Dodge Intrepid: How to I turn on driving lights?

pull on the switch

SOURCE: how to replace a sway bar end links to a 94 intrepid

REMOVAL & INSTALLATION

The rear suspension on LH platform vehicles is a fully independent suspension. A stabilizer bar (also called a sway bar) is mounted in rubber isolator bushings and connects the rear struts through links. Note that the fuel tank must be removed to remove the stabilizer bar.

CAUTION OFF. The fuel system pressure must be relieved before disconnecting any fuel lines. Failure to do so may result in fire and/or personal injury.

1. Disconnect the negative battery cable. Relieve the fuel system pressure.
2. Raise and safely support the vehicle.
3. Remove both rear wheels.

1. Position a transmission jack under the fuel tank just forward of the crossmember to help support the fuel tank when crossmember is removed.
2. Remove the four crossmember to frame rail attaching bolts. Remove the fuel tank.
3. Remove the stabilizer bar to link assembly attaching nuts and remove the bar and isolator bushings as an assembly from the vehicle. Inspect the isolator bushings for damage or excessive wear and replace, if necessary.

1. Inspect for broken or distorted retainers and bushings. If bushing replacement is required, replacement bushings can be installed by locating the split in the bushing, prying open and removing the defective bushing from around the stabilizer bar.
2. Install the stabilizer bar and isolator bushings back into the vehicle as an assembly making sure bar is centered in vehicle so it doesn't contact other suspension components.
3. Install stabilizer bar attaching link onto stabilizer bar. Install new link to bar attaching nuts and tighten to 70 ft. lbs. (95 Nm).

1. Install the fuel tank back onto the vehicle.
2. Position the crossmember on frame rails and install four mounting bolts. Tighten attaching bolts to 70 ft. lbs. (95 Nm).
3. Remove transmission jack from under the fuel tank.
4. Install the rear wheels and lug nuts. Tighten the lug nuts, in a star pattern sequence, to 95-100 ft. lbs. (129-135 Nm).
5. Lower the vehicle. Reconnect the negative battery cable.
6. Pressurize the fuel system and check for leaks.
7. Check and reset the rear wheel toe to specifications as required.

SOURCE: how to replace headlight for 2001 dodge intrepid

The easiest way to do it is to remove the whole headlight. Pop the hood of your car and look at the metal frame over your headlights. This frame is the color of your car. There should be two flat black bolts holding the headlight in. They are very long bolts. When it looks like the bolt is just spinning in place pull the bolt straight up. After you have done this the headlight should be free. Pull the headlight forward. There are wires attached to the back of the headlight, so don't pull too far, or too hard. When you have gotten to this point, follow the wires to the back of the headlight fixture. Grab the plastic piece that the wires are going into and turn in 1/4 to 1/2 a turn counter clockwise and pull out. This should be your headlight. Put the new one in and follow the same steps in reverse. If you have any problems, just tell me and I can be more specific or post pics.