How do I reset the code to get the radio working after a battery replacement
Hi, to input the code, the radio will need to display CODE. If it displays "OFF" you will need to leave the key in the accessory position for one hour to reset the radio to displaying "CODE" again.
Once CODE is displayed, push the preset button 1 to set the first digit, preset button 2 to set the second digit, and so on.
Once the code is displayed correctly, push the unlock button for your radio. This varies by radio but is always either CD, AM/FM, or TAPE. There is no penalty for pushing the wrong unlock button as long as the code displayed is correct. When you push the unlock button for your radio, it will turn the radio on, and to AM. You have full operation of the radio after this.
If you have a problem or think your code may not be right, provide the serial number from the top of the radio and I can verify your unlock code.
Regarding ali, please do not post answers to questions you admittedly have no idea about. It gives the site a bad rep.
SOURCE: reset code mitsubishi car radio
.hi
follow this
place the ignition key in the "ACC" position
. Press the POWER button, and "codE" will be shown on the display.
Press NO.1 through NO.4 memory select buttons to set the four-digit security code indicated on the card. Every time the digit key is pressed, the figure changes as follows:
0-1-2-3-4-5-6-7-8-9
. Press the TAPE button, and a beep will be heard and the audio system will be at normal condition
thank u.........................
SOURCE: radio code for a 2000 mitsubishi
Call your local dealership
Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/sean_54c3a3dc48a7773c
523 views
Usually answered in minutes!
I have the code, how do I input it?
Pull the radio to get the serial number from the sticker on the top of the case. Post the serial number here and I can provide the unlock code for you
×