Question about Mercury Villager

1 Answer

1993 mercury villager with growling power steering. it started after a power steering flush. mechanic has replaced power steering pump. can the pump output be looped back to itself without damaging the pump to isolate the problem to either the pump or the steering mechanism?

Posted by on

  • Marvin
    Marvin May 11, 2010

    was this a new or rebuilt pump? was the air properly bled from the system?

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 355 Answers

WELL YOU COULD PULL THE BELT TO SEE IF IT GOSE AWAY BUT ITS SOUND LIKE THEY DID SOMTHING RONG OR THEY RAN IT LOW OR SOMTHING IS NOT RIGHT WITH NEW PUMP SEAN THIS MANY TIMES IF THERE NOT BLEEDING IT RIGHT YOU CAN DAMAGE THE PUMP RIGHT AWAY SEEN DEARL SHIP GUYS DAMAGE PUMP BUY NOT DOING IT RIGHT AND BE SURE THEY ARE NOT USEING AFTER MARKET STUFF MANY ISUSES WITH THEM THIS CAR IS NOWEN TO HAVE TIE ROD END ISUSES THEY SOUND LIKE GROWLING NOISE HOPE THIS HELPS

Posted on Oct 27, 2009

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Much will cost replace power steering


the hard power steering is given away by the loud squeaky noise . It is the drive bely slipping from worn out or needs adjustment.. If the key problem is in the switch the replace the switch of if it is not engaging the starter motor have a look at the battery connections (shiny clean and tight) or the solenoid or starter relay.

Jan 09, 2014 | Mercury Cars & Trucks

1 Answer

1993 mecury wont start


The electronics inside the Mercury Villager are slightly primitive, however there should be a third wire connected to the original fuel pump, and it must be taken off and put onto the new fuel pump, this becomes a ground wire.

Aug 10, 2012 | 1993 Mercury Villager

4 Answers

Power steering is stiff when first start up


Have you checked the steering fluid? If that is good, it may be the pump

Feb 23, 2011 | 2001 Mercury Villager

1 Answer

I need a new steering pump for my 1995 Villager. My mechanic has replaced the old three aftermarket pumps and they all are very noisey. Help!


well.. look like the problem is no the pump, is the fluid your mechanic is using.
this p/s pump use a "FORD PREMIUM POWER STEERING FLUID".
Flush the system and replace the fluid. after do that no more noise. warranty!!.

Apr 01, 2010 | 1995 Mercury Villager

1 Answer

Power steering pump noise on mercury villager when turning to rig


Had the same problem and the only way to fix it was replacing the steering pump.

Sep 28, 2009 | 1995 Mercury Villager

1 Answer

Easy steering to left, difficult steering to right


he sounds right on that one..sounds like bad seal in the steering box or bad valve.--as far as replacing the power steering pump---i wouldnt do that unless its growling right now. the lines will be disconnected from the steering box, now is a great time to flush the power steering pump. but yes, i think he is on the right track with the steering box being bad

Jun 23, 2009 | 2004 GMC Yukon

2 Answers

Power steering


You have to bleed the pump and rent a pulley puller but if you are mechanically inclined it should be relatively easy although time consuming.I am attaching a pictureca783e0.jpg

Jun 17, 2009 | 1998 Mercury Villager

1 Answer

Ran out of gas. after putting gas into my 93 mercury villager it would not start. please HELP


2 Suggestions:
Check the gas reset button located besides the parking brake pedal (red button), press it and try to turn it on.
Check with a mechanic if the gas pump still works (if you ran out of gas you could probably have damaged your gas pumpby overheating it)

Mar 30, 2009 | 1993 Mercury Villager

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

224 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

gerry bissi

Level 3 Expert

4388 Answers

Marvin
Marvin

Level 3 Expert

85216 Answers

fordexpert

Level 3 Expert

5692 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...