- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
www.allfordmustangs.com > ... > V6 TecCamshaft Position Synchronizer Replacement - YouTube? 1:16https://www.youtube.com/watch?v=fXOJXnYIZQkNov 18, 2009 - Uploaded by 2003FordTaurus2003 Ford Taurus 3.0L Vulcan 181K miles with chirping sound ... does the shaft move out of its place when ...Camshaft Sensor/Synchronizer Replacement - Page 5 - Ford Tru
Code PO1309 : Misfire Monitor Failure
Description : When the misfire monitor is disabled,usually due to the input signal generated by the camshaft position sensor, by sensing the passage of teeth from the camshaft position wheel.
Possible Causes : PCM(power train control module), Mass Air Flow Sensor, Engine Coolant Temperature Sensor, Crank Shaft Position Sensor, Camshaft Position Sensor.
OK, on a 1998 Ford Taurus have a service engine soon light. Scanning it said the Camshaft Sensor circuit was bad. So I replaced the camshaft sensor. Cleared the code and it came back.
In the winter time it comes, and in the summer time it goes away (or after a week or so of warm weather).
I think it's a wiring problem or a bad calibration of distance to the reluctor ring.
I think your problem on the 1997 Ford Thunderbird LX is the same thing.
the input to the sensor must also be checked. this link provides some diagnostic procedures. diagnosis for camshaft and crankshaft sensors are similar, as stated in the article.
Normally the Part on the transmission is a female connector and the part you got out is from the cable. just replace the cable. However, this connector on the transmission should be replaceable as well but will require a Transmission technician to do it.
the throttle position sensor would be about 30- 50 dollars depending on what brand Motorcraft is the factory Oem brand. replacing it only takes about ten minutes
i thought that this was a helpfull sight however i was wrong.
×