1995 Lincoln town car blower motor resistor. Blower runs on high only. Can I replace easy?

Sounds like blower motor resistor. Should be next to blower motor and have several wires coming out of it

Sounds like blower motor resistor is bad.

have you checked the fuses?? does it work on any speeds?? if so probly check the resistor, quiet possibly the blower motor is defective

Hello Sanda.

The blower speed system on your car goes through a resistor to give various speeds.
The reason it still works on high is that when set on high it doesn't go through that resistor.
It gets direct battery voltage.
The resistor is not too expensive and easy to replace.

To replace;

1. Open the glove box.
2. Flex both sides of the glove box bin inward near the top far enough for the rubber glove box stop bumpers to clear the sides of the glove box opening, then roll the glove box downward.

1. Reach through the glove box opening to access and disconnect the instrument panel wire harness connector for the blower motor resistor from the resistor connector receptacle.
2. Reach through the glove box opening to access and disconnect the blower motor pigtail wire connector from the resistor connector receptacle.
3. Remove the two screws that secure the blower motor resistor to the evaporator housing.
4. Remove the blower motor resistor from the evaporator housing.

There you are. Thank you for using FixYa.

KL

Run a jumper to the motor directly from the battery, if it works you have wiring problem, if not replace the blower.

the blower won't come on in a 1995 lincoln towncar, could it be a blower resistor?

u willl need to replace the blower motor speed control resistor.

The blower motor resistor is located near the blower motor. It is held in place by 2 screws, and has a wire clip connected to it. Very simple fix.

I hope this helps you, and I wish you luck on your repair.

Hello Callahan5922....this sounds like a stuck blower motor resistor. I assume the blower won't function in the a/c mode either? If you have a digital multimeter you can check this. I believe it's fuse #2....if the digital indicator goes up or down when you increase or decrease the fan speed thats good. Locate the blower motor resistor....you wil find it located on the fire wall behind the right valve cover hiding behind the heater hose, it's about the size of a cigarette pack. With the engine off, and key in on position, turn the A/C on High, and rap a tap tap tap on the resistor. You might be suprised when the blower motor takes off a runnin,
I hope this is the answer you need and i was able to help solve this for you. Good luck...

it is called blower motor resistor , should be close to blower motor , you will see a plug type connector with two screws , remove the screws and there should be a resistor inside the cover for the motor, swap with new and reassemble